Re: tg3 link state detection

[Andre Tomt <andre@tomt.net>]

Andre Tomt wrote:
> With 2.6.8(.1)+the add_pin_to_irq fix we're seeing problem with link 
> state detection using tg3 devices. The network in question has a severe 
> case of cable monkeys, so the link is a bit jumpy.
> 
>  From time to time the tg3's do not detect that the link is up again, 
> and thus has to be rebooted (ifdown/up has not been tested due to 
> triggerhappy non-technical on-site monkeys.)
> 
> Is this a known problem?
> 
>> tg3.c:v3.8 (July 14, 2004)
>> ACPI: PCI interrupt 0000:02:00.0[A] -> GSI 16 (level, low) -> IRQ 185
>> eth0: Tigon3 [partno(BCM95704A6) rev 2002 PHY(5704)] 
>> (PCIX:133MHz:64-bit) 10/100/1000BaseT Ethernet 00:0d:56:fe:4f:e7
>> eth0: HostTXDS[1] RXcsums[1] LinkChgREG[1] MIirq[1] ASF[0] Split[0] 
>> WireSpeed[1] TSOcap[1]
>> ACPI: PCI interrupt 0000:02:00.1[B] -> GSI 17 (level, low) -> IRQ 193
>> eth1: Tigon3 [partno(BCM95704A6) rev 2002 PHY(5704)] 
>> (PCIX:133MHz:64-bit) 10/100/1000BaseT Ethernet 00:0d:56:fe:4f:e8
>> eth1: HostTXDS[1] RXcsums[1] LinkChgREG[1] MIirq[1] ASF[0] Split[0] 
>> WireSpeed[1] TSOcap[1]

I forgot to mention, these are copper tg3 nic's, not fibre (I know the 
fibre negatioation code has recieved some attention post-2.6.8)