* sky2 hang.
@ 2006-10-31 6:11 Evgeniy Polyakov
2006-10-31 6:24 ` Stephen Hemminger
0 siblings, 1 reply; 5+ messages in thread
From: Evgeniy Polyakov @ 2006-10-31 6:11 UTC (permalink / raw)
To: Stephen Hemminger; +Cc: netdev
sky2 from debian etch kernel (2.6.17-2) has stopped today after quite
big amount of traffic transferred (30MB/sec for about 3-4 hours).
rmmod/insmod does not help, reboot required.
Here is dmesg output:
Oct 31 06:40:07 kano kernel: NETDEV WATCHDOG: eth0: transmit timed out
Oct 31 06:40:07 kano kernel: sky2 eth0: tx timeout
Oct 31 06:40:07 kano kernel: sky2 eth0: transmit ring 198 .. 175 report=221 done=221
Oct 31 06:40:07 kano kernel: sky2 status report lost?
Oct 31 06:40:42 kano kernel: NETDEV WATCHDOG: eth0: transmit timed out
Oct 31 06:40:42 kano kernel: sky2 eth0: tx timeout
Oct 31 06:40:42 kano kernel: sky2 eth0: transmit ring 221 .. 198 report=221 done=221
Oct 31 06:40:42 kano kernel: sky2 hardware hung? flushing
Oct 31 06:54:07 kano kernel: NETDEV WATCHDOG: eth0: transmit timed out
Oct 31 06:54:07 kano kernel: sky2 eth0: tx timeout
Oct 31 06:54:07 kano kernel: sky2 eth0: transmit ring 198 .. 175 report=221 done=221
Oct 31 06:54:07 kano kernel: sky2 status report lost?
Oct 31 06:54:42 kano kernel: NETDEV WATCHDOG: eth0: transmit timed out
Oct 31 06:54:42 kano kernel: sky2 eth0: tx timeout
Oct 31 06:54:42 kano kernel: sky2 eth0: transmit ring 221 .. 198 report=221 done=221
Oct 31 06:54:42 kano kernel: sky2 hardware hung? flushing
And here is rmmod/insmod dmesg:
Oct 31 08:58:19 kano kernel: sky2 eth0: disabling interface
Oct 31 08:59:00 kano kernel: ACPI: PCI interrupt for device 0000:05:00.0 disabled
Oct 31 08:59:21 kano kernel: ACPI: PCI Interrupt 0000:05:00.0[A] -> Link [LNKD] -> GSI 18 (level, low) -> IRQ 98
Oct 31 08:59:21 kano kernel: PCI: Setting latency timer of device 0000:05:00.0 to 64
Oct 31 08:59:21 kano kernel: sky2 v1.6.1 addr 0xfbefc000 irq 98 Yukon-EC (0xb6) rev 2
Oct 31 08:59:21 kano kernel: sky2 eth0: addr 00:17:31:9a:e5:be
Oct 31 08:59:21 kano kernel: sky2 eth0: enabling interface
Oct 31 08:59:21 kano kernel: ADDRCONF(NETDEV_UP): eth0: link is not ready
Oct 31 08:59:23 kano kernel: sky2 eth0: Link is up at 1000 Mbps, full duplex, flow control both
Oct 31 08:59:23 kano kernel: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
--
Evgeniy Polyakov
^ permalink raw reply [flat|nested] 5+ messages in thread
* Re: sky2 hang.
2006-10-31 6:11 sky2 hang Evgeniy Polyakov
@ 2006-10-31 6:24 ` Stephen Hemminger
2006-10-31 7:04 ` Evgeniy Polyakov
0 siblings, 1 reply; 5+ messages in thread
From: Stephen Hemminger @ 2006-10-31 6:24 UTC (permalink / raw)
To: Evgeniy Polyakov; +Cc: netdev
Evgeniy Polyakov wrote:
> sky2 from debian etch kernel (2.6.17-2) has stopped today after quite
> big amount of traffic transferred (30MB/sec for about 3-4 hours).
> rmmod/insmod does not help, reboot required.
>
> Here is dmesg output:
>
> Oct 31 06:40:07 kano kernel: NETDEV WATCHDOG: eth0: transmit timed out
> Oct 31 06:40:07 kano kernel: sky2 eth0: tx timeout
> Oct 31 06:40:07 kano kernel: sky2 eth0: transmit ring 198 .. 175 report=221 done=221
> Oct 31 06:40:07 kano kernel: sky2 status report lost?
> Oct 31 06:40:42 kano kernel: NETDEV WATCHDOG: eth0: transmit timed out
> Oct 31 06:40:42 kano kernel: sky2 eth0: tx timeout
> Oct 31 06:40:42 kano kernel: sky2 eth0: transmit ring 221 .. 198 report=221 done=221
> Oct 31 06:40:42 kano kernel: sky2 hardware hung? flushing
> Oct 31 06:54:07 kano kernel: NETDEV WATCHDOG: eth0: transmit timed out
> Oct 31 06:54:07 kano kernel: sky2 eth0: tx timeout
> Oct 31 06:54:07 kano kernel: sky2 eth0: transmit ring 198 .. 175 report=221 done=221
> Oct 31 06:54:07 kano kernel: sky2 status report lost?
> Oct 31 06:54:42 kano kernel: NETDEV WATCHDOG: eth0: transmit timed out
> Oct 31 06:54:42 kano kernel: sky2 eth0: tx timeout
> Oct 31 06:54:42 kano kernel: sky2 eth0: transmit ring 221 .. 198 report=221 done=221
> Oct 31 06:54:42 kano kernel: sky2 hardware hung? flushing
>
> And here is rmmod/insmod dmesg:
>
> Oct 31 08:58:19 kano kernel: sky2 eth0: disabling interface
> Oct 31 08:59:00 kano kernel: ACPI: PCI interrupt for device 0000:05:00.0 disabled
> Oct 31 08:59:21 kano kernel: ACPI: PCI Interrupt 0000:05:00.0[A] -> Link [LNKD] -> GSI 18 (level, low) -> IRQ 98
> Oct 31 08:59:21 kano kernel: PCI: Setting latency timer of device 0000:05:00.0 to 64
> Oct 31 08:59:21 kano kernel: sky2 v1.6.1 addr 0xfbefc000 irq 98 Yukon-EC (0xb6) rev 2
> Oct 31 08:59:21 kano kernel: sky2 eth0: addr 00:17:31:9a:e5:be
> Oct 31 08:59:21 kano kernel: sky2 eth0: enabling interface
> Oct 31 08:59:21 kano kernel: ADDRCONF(NETDEV_UP): eth0: link is not ready
> Oct 31 08:59:23 kano kernel: sky2 eth0: Link is up at 1000 Mbps, full duplex, flow control both
> Oct 31 08:59:23 kano kernel: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
>
>
Run 2.6.19-rc3 or 2.6.18.2 or dig out the patch from last week.
^ permalink raw reply [flat|nested] 5+ messages in thread
* Re: sky2 hang.
2006-10-31 6:24 ` Stephen Hemminger
@ 2006-10-31 7:04 ` Evgeniy Polyakov
2006-10-31 7:08 ` Alexander Wirt
0 siblings, 1 reply; 5+ messages in thread
From: Evgeniy Polyakov @ 2006-10-31 7:04 UTC (permalink / raw)
To: Stephen Hemminger; +Cc: netdev
On Mon, Oct 30, 2006 at 10:24:18PM -0800, Stephen Hemminger (shemminger@osdl.org) wrote:
> Run 2.6.19-rc3 or 2.6.18.2 or dig out the patch from last week.
Thanks.
I hope debian maintainers will rebase it's tree eventually.
--
Evgeniy Polyakov
^ permalink raw reply [flat|nested] 5+ messages in thread
* Re: sky2 hang.
2006-10-31 7:04 ` Evgeniy Polyakov
@ 2006-10-31 7:08 ` Alexander Wirt
2006-10-31 7:33 ` Evgeniy Polyakov
0 siblings, 1 reply; 5+ messages in thread
From: Alexander Wirt @ 2006-10-31 7:08 UTC (permalink / raw)
To: Evgeniy Polyakov; +Cc: netdev
Evgeniy Polyakov schrieb am Dienstag, den 31. Oktober 2006:
> On Mon, Oct 30, 2006 at 10:24:18PM -0800, Stephen Hemminger (shemminger@osdl.org) wrote:
> > Run 2.6.19-rc3 or 2.6.18.2 or dig out the patch from last week.
>
> Thanks.
> I hope debian maintainers will rebase it's tree eventually.
Then please take sure that there is a bug report describing
ther problem (maybe with a patch?).
Alex
P.S. No I don't have anything to do with the kernel team :).
^ permalink raw reply [flat|nested] 5+ messages in thread
* Re: sky2 hang.
2006-10-31 7:08 ` Alexander Wirt
@ 2006-10-31 7:33 ` Evgeniy Polyakov
0 siblings, 0 replies; 5+ messages in thread
From: Evgeniy Polyakov @ 2006-10-31 7:33 UTC (permalink / raw)
To: Alexander Wirt; +Cc: netdev
On Tue, Oct 31, 2006 at 08:08:12AM +0100, Alexander Wirt (formorer@debian.org) wrote:
> > > Run 2.6.19-rc3 or 2.6.18.2 or dig out the patch from last week.
> >
> > Thanks.
> > I hope debian maintainers will rebase it's tree eventually.
> Then please take sure that there is a bug report describing
> ther problem (maybe with a patch?).
>
> Alex
>
> P.S. No I don't have anything to do with the kernel team :).
I've created one using reportbug (even not created, but provided as
additional info to some other bug), hope it is correct.
It's number is 396185.
P.S. IMHO Debian bug reporting tool is the most unconvenient thing in
the whole distro :)
--
Evgeniy Polyakov
^ permalink raw reply [flat|nested] 5+ messages in thread
end of thread, other threads:[~2006-10-31 7:33 UTC | newest]
Thread overview: 5+ messages (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2006-10-31 6:11 sky2 hang Evgeniy Polyakov
2006-10-31 6:24 ` Stephen Hemminger
2006-10-31 7:04 ` Evgeniy Polyakov
2006-10-31 7:08 ` Alexander Wirt
2006-10-31 7:33 ` Evgeniy Polyakov
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).