Re: [PATCH net-next v2 1/2] net: dsa: mt7530-mdio: read PHY address of switch from device tree

[Florian Fainelli <f.fainelli@gmail.com>]

On 4/13/2024 11:07 PM, Arınç ÜNAL via B4 Relay wrote:
> From: Arınç ÜNAL <arinc.unal@arinc9.com>
> 
> Read the PHY address the switch listens on from the reg property of the
> switch node on the device tree. This change brings support for MT7530
> switches on boards with such bootstrapping configuration where the switch
> listens on a different PHY address than the hardcoded PHY address on the
> driver, 31.
> 
> As described on the "MT7621 Programming Guide v0.4" document, the MT7530
> switch and its PHYs can be configured to listen on the range of 7-12,
> 15-20, 23-28, and 31 and 0-4 PHY addresses.
> 
> There are operations where the switch PHY registers are used. For the PHY
> address of the control PHY, transform the MT753X_CTRL_PHY_ADDR constant
> into a macro and use it. The PHY address for the control PHY is 0 when the
> switch listens on 31. In any other case, it is one greater than the PHY
> address the switch listens on.
> 
> Reviewed-by: Daniel Golle <daniel@makrotopia.org>
> Tested-by: Daniel Golle <daniel@makrotopia.org>
> Signed-off-by: Arınç ÜNAL <arinc.unal@arinc9.com>

Reviewed-by: Florian Fainelli <florian.fainelli@broadcom.com>

I would go a step further and name phy_addr switch_mdio_addr, or 
something along those lines to clearly denote this is not a per-port PHY 
address neither a proper PHY device, but we've already had a similar 
discussion before about spelling this out clearly as a "pseudo PHY"....
-- 
Florian