netdev.vger.kernel.org archive mirror
 help / color / mirror / Atom feed
From: Moni Shoua <monis@voltaire.com>
To: rdreier@cisco.com,  davem@davemloft.net,  fubar@us.ibm.com
Cc: netdev@vger.kernel.org, general@lists.openfabrics.org
Subject: [ofa-general] [PATCH V3 5/7] net/bonding: Enable IP multicast for bonding IPoIB devices
Date: Mon, 30 Jul 2007 15:54:03 +0300	[thread overview]
Message-ID: <46ADDF6B.1080907@voltaire.com> (raw)
In-Reply-To: <46ADDB89.5030601@voltaire.com>


Allow to enslave devices when the bonding device is not up. Over the discussion
held at the previous post this seemed to be the most clean way to go, where it
is not expected to cause instabilities.

Normally, the bonding driver is UP before any enslavement takes place.
Once a netdevice is UP, the network stack acts to have it join some multicast groups
(eg the all-hosts 224.0.0.1). Now, since ether_setup() have set the bonding device
type to be ARPHRD_ETHER and address len to be ETHER_ALEN, the net core code
computes a wrong multicast link address. This is b/c ip_eth_mc_map() is called
where for multicast joins taking place after the enslavement another ip_xxx_mc_map()
is called (eg ip_ib_mc_map() when the bond type is ARPHRD_INFINIBAND)

Signed-off-by: Moni Shoua <monis@voltaire.com>
Signed-off-by: Or Gerlitz <ogerlitz@voltaire.com>
---
 drivers/net/bonding/bond_main.c  |    4 ++--
 drivers/net/bonding/bond_sysfs.c |    6 ++----
 2 files changed, 4 insertions(+), 6 deletions(-)

Index: net-2.6/drivers/net/bonding/bond_main.c
===================================================================
--- net-2.6.orig/drivers/net/bonding/bond_main.c	2007-07-25 15:04:50.000000000 +0300
+++ net-2.6/drivers/net/bonding/bond_main.c	2007-07-25 15:06:17.175820632 +0300
@@ -1325,8 +1325,8 @@ int bond_enslave(struct net_device *bond
 
 	/* bond must be initialized by bond_open() before enslaving */
 	if (!(bond_dev->flags & IFF_UP)) {
-		dprintk("Error, master_dev is not up\n");
-		return -EPERM;
+		printk(KERN_WARNING DRV_NAME
+			" %s: master_dev is not up in bond_enslave\n", bond_dev->name);
 	}
 
 	/* already enslaved */
Index: net-2.6/drivers/net/bonding/bond_sysfs.c
===================================================================
--- net-2.6.orig/drivers/net/bonding/bond_sysfs.c	2007-07-25 14:18:12.000000000 +0300
+++ net-2.6/drivers/net/bonding/bond_sysfs.c	2007-07-25 15:06:17.176820452 +0300
@@ -266,11 +266,9 @@ static ssize_t bonding_store_slaves(stru
 
 	/* Quick sanity check -- is the bond interface up? */
 	if (!(bond->dev->flags & IFF_UP)) {
-		printk(KERN_ERR DRV_NAME
-		       ": %s: Unable to update slaves because interface is down.\n",
+		printk(KERN_WARNING DRV_NAME
+		       ": %s: doing slave updates when interface is down.\n",
 		       bond->dev->name);
-		ret = -EPERM;
-		goto out;
 	}
 
 	/* Note:  We can't hold bond->lock here, as bond_create grabs it. */

  parent reply	other threads:[~2007-07-30 12:54 UTC|newest]

Thread overview: 20+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2007-07-30 12:37 [ofa-general] [PATCH V3 0/7] net/bonding: ADD IPoIB support for the bonding driver Moni Shoua
2007-07-30 12:48 ` [ofa-general] [PATCH V3 1/7] IB/ipoib: Bound the net device to the ipoib_neigh structue Moni Shoua
2007-07-30 12:49 ` [ofa-general] [PATCH V3 2/7] IB/ipoib: Verify address handle validity on send Moni Shoua
2007-07-30 12:51 ` [ofa-general] [PATCH V3 3/7] net/bonding: Enable bonding to enslave non ARPHRD_ETHER Moni Shoua
2007-07-30 12:52 ` [ofa-general] [PATCH V3 4/7] net/bonding: Enable bonding to enslave netdevices not supporting set_mac_address() Moni Shoua
2007-07-30 12:54 ` Moni Shoua [this message]
2007-07-30 12:54 ` [ofa-general] [PATCH V3 6/7] net/bonding: Handlle wrong assumptions that slave is always an Ethernet device Moni Shoua
2007-07-30 12:56 ` [ofa-general] [PATCH V3 7/7] net/bonding: Delay sending of gratuitous ARP to avoid failure Moni Shoua
2007-07-30 20:29   ` [ofa-general] " Jay Vosburgh
2007-07-31 13:33     ` Moni Shoua
2007-07-30 21:20 ` [PATCH V3 0/7] net/bonding: ADD IPoIB support for the bonding driver Roland Dreier
2007-07-31 13:44   ` [ofa-general] " Moni Shoua
2007-07-31 14:04     ` [ofa-general] " Michael S. Tsirkin
2007-07-31 14:19       ` Or Gerlitz
2007-07-31 14:22         ` [ofa-general] " Michael S. Tsirkin
2007-07-31 14:36           ` Or Gerlitz
2007-07-31 14:48             ` Michael S. Tsirkin
2007-07-31 14:57               ` [ofa-general] " Or Gerlitz
2007-08-01 14:12           ` [ofa-general] Re: " Moni Shoua
2007-08-01 16:10             ` Michael S. Tsirkin

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=46ADDF6B.1080907@voltaire.com \
    --to=monis@voltaire.com \
    --cc=davem@davemloft.net \
    --cc=fubar@us.ibm.com \
    --cc=general@lists.openfabrics.org \
    --cc=netdev@vger.kernel.org \
    --cc=rdreier@cisco.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).