netdev.vger.kernel.org archive mirror
 help / color / mirror / Atom feed
From: osprey67 <osprey67@yahoo.com>
To: netdev@vger.kernel.org
Subject: [PATCH 04/05] ipv6: RFC4214 Support (4)
Date: Mon, 12 Nov 2007 07:55:04 -0800	[thread overview]
Message-ID: <47387758.7080101@yahoo.com> (raw)
In-Reply-To: <4734FCEF.3080301@yahoo.com>

From: Fred L. Templin <fred.l.templin@boeing.com>

This is experimental support for the Intra-Site Automatic
Tunnel Addressing Protocol (ISATAP) per RFC4214. It uses
the SIT module, and is configured using the unmodified
"ip" utility with device names beginning with: "isatap".

The following diffs are specific to the Linux 2.6.24-rc2
kernel distribution.

Signed-off-by: Fred L. Templin <fred.l.templin@boeing.com>

---

--- linux-2.6.24-rc2/net/ipv6/sit.c.orig        2007-11-08 12:03:41.000000000 -0800
+++ linux-2.6.24-rc2/net/ipv6/sit.c     2007-11-12 07:13:13.000000000 -0800
@@ -16,6 +16,7 @@
   *     Changes:
   * Roger Venning <r.venning@telstra.com>:      6to4 support
   * Nate Thompson <nate@thebog.net>:            6to4 support
+ * Fred L. Templin <fltemplin@acm.org>:                isatap support
   */

  #include <linux/module.h>
@@ -182,6 +183,11 @@ static struct ip_tunnel * ipip6_tunnel_l
         dev->init = ipip6_tunnel_init;
         nt->parms = *parms;

+#if defined(CONFIG_IPV6_ISATAP)
+       if (parms->i_key)
+               dev->priv_flags |= IFF_ISATAP;
+#endif
+
         if (register_netdevice(dev) < 0) {
                 free_netdev(dev);
                 goto failed;
@@ -382,6 +388,48 @@ static int ipip6_rcv(struct sk_buff *skb
                 IPCB(skb)->flags = 0;
                 skb->protocol = htons(ETH_P_IPV6);
                 skb->pkt_type = PACKET_HOST;
+#if defined(CONFIG_IPV6_ISATAP)
+               /* ISATAP (RFC4214) - check source address */
+               if (tunnel->dev->priv_flags & IFF_ISATAP) {
+                       struct neighbour *neigh;
+                       struct dst_entry *dst;
+                       struct flowi fl;
+                       struct in6_addr *addr6;
+                       struct ipv6hdr *iph6;
+
+                       /* from ISATAP router */
+                       if ((tunnel->parms.i_key != INADDR_NONE) &&
+                           (iph->saddr == tunnel->parms.i_key)) goto accept;
+
+                       iph6 = ipv6_hdr(skb);
+                       addr6 = &iph6->saddr;
+
+                       /* from legitimate previous hop */
+                       memset(&fl, 0, sizeof(fl));
+                       fl.proto = iph6->nexthdr;
+                       ipv6_addr_copy(&fl.fl6_dst, addr6);
+                       fl.oif = tunnel->dev->ifindex;
+                       security_skb_classify_flow(skb, &fl);
+
+                       if (!(dst = ip6_route_output(NULL, &fl)) ||
+                            (dst->dev != tunnel->dev) ||
+                            ((neigh = dst->neighbour) == NULL)) goto drop;
+
+                       addr6 = (struct in6_addr*)&neigh->primary_key;
+
+                       if (!(ipv6_addr_is_isatap(addr6)) ||
+                            (addr6->s6_addr32[3] != iph->saddr)) {
+drop:
+                               tunnel->stat.rx_errors++;
+                               read_unlock(&ipip6_lock);
+                               dst_release(dst);
+                               kfree_skb(skb);
+                               return 0;
+                       }
+                       dst_release(dst);
+               }
+accept:
+#endif
                 tunnel->stat.rx_packets++;
                 tunnel->stat.rx_bytes += skb->len;
                 skb->dev = tunnel->dev;
@@ -444,6 +492,31 @@ static int ipip6_tunnel_xmit(struct sk_b
         if (skb->protocol != htons(ETH_P_IPV6))
                 goto tx_error;

+#if defined(CONFIG_IPV6_ISATAP)
+       /* ISATAP (RFC4214) - must come before 6to4 */
+       if (dev->priv_flags & IFF_ISATAP) {
+               struct neighbour *neigh = NULL;
+
+               if (skb->dst)
+                       neigh = skb->dst->neighbour;
+
+               if (neigh == NULL) {
+                       if (net_ratelimit())
+                               printk(KERN_DEBUG "sit: nexthop == NULL\n");
+                       goto tx_error;
+               }
+
+               addr6 = (struct in6_addr*)&neigh->primary_key;
+               addr_type = ipv6_addr_type(addr6);
+
+               if ((addr_type & IPV6_ADDR_UNICAST) &&
+                    ipv6_addr_is_isatap(addr6))
+                       dst = addr6->s6_addr32[3];
+               else
+                       goto tx_error;
+       }
+#endif
+
         if (!dst)
                 dst = try_6to4(&iph6->daddr);

@@ -651,6 +724,10 @@ ipip6_tunnel_ioctl (struct net_device *d
                                 ipip6_tunnel_unlink(t);
                                 t->parms.iph.saddr = p.iph.saddr;
                                 t->parms.iph.daddr = p.iph.daddr;
+#if defined(CONFIG_IPV6_ISATAP)
+                               t->parms.i_key = p.i_key;
+                               t->parms.o_key = p.o_key;
+#endif
                                 memcpy(dev->dev_addr, &p.iph.saddr, 4);
                                 memcpy(dev->broadcast, &p.iph.daddr, 4);
                                 ipip6_tunnel_link(t);
@@ -663,6 +740,10 @@ ipip6_tunnel_ioctl (struct net_device *d
                         if (cmd == SIOCCHGTUNNEL) {
                                 t->parms.iph.ttl = p.iph.ttl;
                                 t->parms.iph.tos = p.iph.tos;
+#if defined(CONFIG_IPV6_ISATAP)
+                               t->parms.i_key = p.i_key;
+                               t->parms.o_key = p.o_key;
+#endif
                         }
                         if (copy_to_user(ifr->ifr_ifru.ifru_data, &t->parms, sizeof(p)))
                                 err = -EFAULT;

  parent reply	other threads:[~2007-11-12 17:52 UTC|newest]

Thread overview: 21+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2007-11-08 20:29 [PATCH 01/05] ipv6: RFC4214 Support (2) osprey67
2007-11-10  0:34 ` [PATCH 01/05] ipv6: RFC4214 Support (3) osprey67
2007-11-10  0:35 ` [PATCH 02/05] " osprey67
2007-11-10  0:35 ` [PATCH 03/05] " osprey67
2007-11-10  0:35 ` [PATCH 04/05] " osprey67
2007-11-10  0:35 ` [PATCH 05/05] " osprey67
2007-11-10  0:42   ` [PATCH 01/01] iproute2-2.6.23: " osprey67
2007-11-10  1:04     ` Patrick McHardy
2007-11-12 15:57     ` [PATCH 01/01] iproute2-2.6.23: RFC4214 Support (4) osprey67
2007-11-12 17:55     ` Templin, Fred L
2007-11-10  1:44   ` [PATCH 05/05] ipv6: RFC4214 Support (3) YOSHIFUJI Hideaki / 吉藤英明
2007-11-12 15:54   ` [PATCH 01/05] ipv6: RFC4214 Support (4) osprey67
2007-11-12 15:54   ` [PATCH 02/05] " osprey67
2007-11-12 15:54   ` [PATCH 03/05] " osprey67
2007-11-12 15:55   ` osprey67 [this message]
2007-11-12 15:55   ` [PATCH 05/05] " osprey67
2007-11-12 17:48   ` Templin, Fred L
2007-11-13 20:53   ` [PATCH 05/05] ipv6: RFC4214 Support (3) Stephen Hemminger
2007-11-14  5:05     ` David Miller
2007-11-14  5:11       ` Stephen Hemminger
2007-11-14 20:09         ` Vlad Yasevich

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=47387758.7080101@yahoo.com \
    --to=osprey67@yahoo.com \
    --cc=netdev@vger.kernel.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).