Re: [PATCH 2/2] r8169: checks against wrong mac addresse init

[Ivan Vecera <ivecera@redhat.com>]

Martin Capitanio wrote:
> Please take a look at the realtek r8101_n aka RealTek RTL8101E,
> RTL8102E(L) code. Only CFG_METHOD_1, CFG_METHOD_2
> and #(ioaddr, 0x00) == 0x8128 are here allowed to EEPROM access.
> 
> ...
> 	rtl_eeprom_write_sc(ioaddr, 0x00, 0x8129);
> 
> 	RTL_W8(Cfg9346, Cfg9346_EEM0);
> 	mdelay(15);
> 	rtl_eeprom_write_sc(ioaddr, 0x00, 0x8128);

1) According specification when EEM0 is set to 1 and EEM1 is set to 0
then adapter enters "auto load" mode. Entering this mode will make the
adapter load the contents of the 93C46 (93C56) as when the PCI RSTB
signal is asserted. This auto-load operation will take about 2 ms.
Upon completion, the it automatically returns to normal mode
(EEM1 = EEM0 = 0) and all of the other registers are reset to default
values.
2) First 2 bytes of the EEPROM contain ID code words for the adapter.
It will load the contents of the EEPROM into the corresponding location
if the ID word (0x8129) is correct.

So the Realtek's driver at first sets these bytes to value 0x8129 to ensure
that auto-load will be a success. Then it initiates auto-load (EMM0 = 1 and
EMM1 = 0) then wait some time and finally writes back original value (0x8128).

Ivan