Re: question about softirqs

["Chris Friesen" <cfriesen@nortel.com>]

This started out as a thread on the ppc list, but on the suggestion of
DaveM and Paul Mackerras I'm expanding the receiver list a bit.

Currently, if a softirq is raised in process context the
TIF_RESCHED_PENDING flag gets set and on return to userspace we run the
scheduler, expecting it to switch to ksoftirqd to handle the softirqd
processing.

I think I see a possible problem with this. Suppose I have a SCHED_FIFO
task spinning on recvmsg() with MSG_DONTWAIT set. Under the scenario
above, schedule() would re-run the spinning task rather than ksoftirqd,
thus preventing any incoming packets from being sent up the stack until
we get a real hardware interrupt--which could be a whole jiffy if
interrupt mitigation is enabled in the net device.

DaveM pointed out that if we're doing transmits we're likely to hit
local_bh_enable(), which would process the softirq work.  However, I
think we may still have a problem in the above rx-only scenario--or is
it too contrived to matter?

Thanks,

Chris