Re: [announce] new rt2800 drivers for Ralink wireless & project tree

[Gertjan van Wingerde <gwingerde-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org>]

Hi,

On 11/03/09 19:51, Bartlomiej Zolnierkiewicz wrote:
> 
> Hi,
> 
> The following patch series (against wireless-next) addresses issues raised
> during code review and subsequently rejected by rt2x00/wireless/networking
> maintainers.
> 

This seems to be a misrepresentation of the situation. The issues raised by
you were acknowledged as being valid, however they were not deemed important
enough to stop inclusion in wireless-next and net-next.

However, it is good to see that you have put effort in providing a patch series
for these issues.

Now, since I believe that it is better to work with people, rather than against
them, would it be possible to post this patch series somewhere as a set of 
separate patches, so that they can be reviewed as such?

---
Gertjan
rt2x00 project developer


> 
> Namely, it:
> 
> - Adds abstraction of chipset register access for chipsets connected to
>   different buses by using new structure (struct rt2800_ops) which contains
>   all needed register access methods.
> 
>   [ It is a prerequisite for fixing code duplication between rt2800usb.c
>     and rt2800pci.c drivers. ]
> 
> - Fixes code duplication in rt2800usb.h and rt2800pci.h header files by
>   using new shared rt2800.h header (almost 1800 LOC gone).
> 
>   Updated debugging scripts are located here:
> 
>       http://www.kernel.org/pub/linux/kernel/people/bart/rt2800/scripts/
> 
>   (they also work fine with older drivers)
> 
> - Adds rt2800 library containing common code for PCI and USB versions
>   of rt2800 chipsets.  This removes over 1300 LOC and allows us to save
>   a lot of maintenance burden in the future. 
> 
> 
> It also fixes two real bugs (one in rt2800pci and one in rt2800usb) found
> as a direct result of the code de-duplication:
> 
> - Fix rt2800usb driver to write the rfcsr read request into RF_CSR_CFG
>   register and not BBP_CSR_CFG one in rt2800usb_rfcsr_read().
> 
> - Use the correct encryption key index for TX frames in rt2800pci (this is
>   based on rt2800usb patch from Benoit PAPILLAULT already in Linus' tree,
>   unfortunately the fix was not ported over to rt2800pci).
> 
>   [ There are also some minor code rt2x00 infrastructure fixes and improvements
>      here and there... ]
> 
> 
> All in all over 3100 LOC are gone and rt2800pci specific code is:
> 
>  1685 drivers/net/wireless/rt2x00/rt2800pci.c
>   180 drivers/net/wireless/rt2x00/rt2800pci.h
>  1865 total
> 
> instead of:
> 
>   3323 drivers/net/wireless/rt2x00/rt2800pci.c
>   1960 drivers/net/wireless/rt2x00/rt2800pci.h
>   5283 total
> 
>   (wireless-next and net-next trees)
> 
> which means decrease of the code needed for rt2800pci by 65% (this in turn
> translates to 31% decrease for rt2800 specific code and 9% for whole rt2x00
> infrastructure).
> 
> The rewrite was quite conservative and there is still a room for improvement
> but it should serve as a good starting base for all future work on rt2800
> drivers, and there is a lot to do there (both drivers are still practically
> non-functional).
> 
> Comments and patches are welcomed.
> 
> 
> The following changes since commit fa867e7355a1bdcd9bf7d55ebe9296f5b9c4028a:
>   Juuso Oikarinen (1):
>         wl1271: Generalize command response reading
> 
> are available in the git repository at:
> 
>   git://git.kernel.org/pub/scm/linux/kernel/git/bart/misc.git rt2800
> 
> Bartlomiej Zolnierkiewicz (40):
>       rt2800usb: fix rt2800usb_rfcsr_read()
>       rt2800pci: fix crypto in TX frame
>       rt2800pci: fix comment about register access
>       rt2800pci: fix comment about IV/EIV fields
>       rt2x00: fix rt2x00usb_register_read() comment
>       rt2800usb: use rt2x00usb_register_multiwrite() to set key entries
>       rt2800usb: add rt2800_register_[read,write]() wrappers
>       rt2800pci: add rt2800_register_[read,write]() wrappers
>       rt2800usb: add rt2800_register_multi[read,write]() wrappers
>       rt2800pci: add rt2800_register_multi[read,write]() wrappers
>       rt2800usb: add rt2800_regbusy_read() wrapper
>       rt2800pci: add rt2800_regbusy_read() wrapper
>       rt2800usb: add rt2800_bbp_[read,write]() wrappers
>       rt2800pci: add rt2800_bbp_[read,write]() wrappers
>       rt2800usb: add rt2800_rfcsr_[read,write]() wrappers
>       rt2800pci: add rt2800_rfcsr_[read,write]() wrappers
>       rt2800usb: add rt2800_rf_[read,write]() wrappers
>       rt2800pci: add rt2800_rf_[read,write]() wrappers
>       rt2800usb: add rt2800_mcu_request() wrapper
>       rt2800pci: add rt2800_mcu_request() wrapper
>       rt2x00: add driver private field to struct rt2x00_dev
>       rt2800usb: convert to use struct rt2800_ops methods
>       rt2800pci: convert to use struct rt2800_ops methods
>       rt2x00: fix rt2x00usb_register_multiwrite() arguments
>       rt2x00: fix rt2x00usb_regbusy_read() arguments
>       rt2x00: fix rt2x00pci_register_multi[read,write]() arguments
>       rt2800: add rt2800lib.h
>       rt2800usb: fix comments in rt2800usb.h
>       rt2800usb: add RXINFO_DESC_SIZE definition
>       rt2800: fix duplication in header files
>       rt2800: fix comments in rt2800.h
>       rt2x00: add support for different chipset interfaces
>       rt2800: prepare for rt2800lib addition
>       rt2800: add rt2800lib (part one)
>       rt2x00: remove needless ifdefs from rt2x00leds.h
>       rt2800: add rt2800lib (part two)
>       rt2x00: move REGISTER_BUSY_* definitions to rt2x00.h
>       rt2800: add rt2800lib (part three)
>       rt2800: add rt2800lib (part four)
>       MAINTAINERS: add rt2800 entry
> 
>  MAINTAINERS                              |    7 +
>  drivers/net/wireless/rt2x00/Kconfig      |    5 +
>  drivers/net/wireless/rt2x00/Makefile     |    1 +
>  drivers/net/wireless/rt2x00/rt2800.h     | 1816 ++++++++++++++++++++++++++++
>  drivers/net/wireless/rt2x00/rt2800lib.c  | 1817 ++++++++++++++++++++++++++++
>  drivers/net/wireless/rt2x00/rt2800lib.h  |  134 +++
>  drivers/net/wireless/rt2x00/rt2800pci.c  | 1908 +++---------------------------
>  drivers/net/wireless/rt2x00/rt2800pci.h  | 1780 ----------------------------
>  drivers/net/wireless/rt2x00/rt2800usb.c  | 1828 ++---------------------------
>  drivers/net/wireless/rt2x00/rt2800usb.h  | 1818 +----------------------------
>  drivers/net/wireless/rt2x00/rt2x00.h     |   33 +
>  drivers/net/wireless/rt2x00/rt2x00leds.h |    4 -
>  drivers/net/wireless/rt2x00/rt2x00pci.h  |   24 +-
>  drivers/net/wireless/rt2x00/rt2x00usb.c  |    2 +-
>  drivers/net/wireless/rt2x00/rt2x00usb.h  |   17 +-
>  15 files changed, 4036 insertions(+), 7158 deletions(-)
>  create mode 100644 drivers/net/wireless/rt2x00/rt2800.h
>  create mode 100644 drivers/net/wireless/rt2x00/rt2800lib.c
>  create mode 100644 drivers/net/wireless/rt2x00/rt2800lib.h
> 
> --
> To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
> the body of a message to majordomo-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
> More majordomo info at  http://vger.kernel.org/majordomo-info.html
> 

--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html