Re: does intel X520-SR(ixgbe) support RSS on single VLAN?

[Alexander Duyck <alexander.h.duyck@intel.com>]

On 1/25/2011 1:03 AM, Rui wrote:
> On Tue, Jan 25, 2011 at 11:05 AM, Ben Hutchings
> <bhutchings@solarflare.com>  wrote:
>> On Tue, 2011-01-25 at 10:10 +0800, Rui wrote:
>>> On Tue, Jan 25, 2011 at 1:09 AM, Alexander Duyck
>>> <alexander.h.duyck@intel.com>  wrote:
>>>> On 1/24/2011 6:18 AM, Rui wrote:
>>>>>
>>>>> hi
>>>>> does intel X520-SR support RSS on single VLAN?
>>>>>
>>>>> tested with 3 different vlan id and priority packets
>>>>> What I saw is that all packets were always delivered to the same RxQ.
>>>>> looks can not get a different RSS index for these packet?
>>>>> any setting needed?
>>>>> --
>>>>> To unsubscribe from this list: send the line "unsubscribe netdev" in
>>>>> the body of a message to majordomo@vger.kernel.org
>>>>> More majordomo info at  http://vger.kernel.org/majordomo-info.html
>>>>
>>>> The X520 should have no problems hashing on a single VLAN tagged frame.
>>>>   However the VLAN will not be a part of the RSS hash.  The  only components
>>>> of the hash are the IPv4/IPv6 source and destination addresses, and if the
>>>> flow is TCP then the port numbers.
>>>>
>>> hi alexander
>>> I got these information from the intel community:
>>>
>>> 'I asked our software engineers about your question, and this is what I learned.
>>> You cannot filter by just VLAN or VLAN priority.  The L4 type will
>>> also play a role in the filter and as such you would only be able to
>>> filter TCP, UDP, and SCTP packets that are bound for a VLAN.
>>> The command itself to setup a filter is “ethtool –U ethX flow-type
>>> tcp4 vlan 0x2000 vlan-mask 0xE000 action Y” where X is the correct
>>> index for the interface and Y is the queue you want to route the
>>> traffic to.  This would have to be repeated for udp4 and sctp4.
>>> I hope this will help.
>>> Mark H"
>>
>> The mask specifies bits to be ignored, so if you want to filter on the
>> basis of only the priority bits you should use vlan-mask 0xfff.  Unless
>> this is another inconsistency I failed to notice...
>>
>>> so my question is that the VLAN is PART of the RSS or not?
>>
>> It's not part of any specified Toeplitz hash.  However, some hardware
>> supports adding the hash (after indirection) to the queue number
>> specified by a filter.  Currently the ethtool API doesn't have a way to
>> request that.
>>
>>> looks the
>>> perfect filter support vlan id ?can the perfect filter support
>>> wildchar,such as: flow-type ANY?
>>
>> It is possible to specify this using flow-type ether, but the ixgbe
>> driver does not yet support that (and I have no idea whether the
>> hardware does).
>>
>> Ben.
>>
>> --
>> Ben Hutchings, Senior Software Engineer, Solarflare Communications
>> Not speaking for my employer; that's the marketing department's job.
>> They asked us to note that Solarflare product names are trademarked.
>>
>>
>
> I got this msg:
> Cannot add new RX n-tuple filter: Operation not supported
> This command is only supported after 2.6.34?

Yes, this command will only work on 2.6.34 and older kernels.

Thanks,

Alex