Re: [PATCH] net/can: activate bit-timing calculation and netlink based drivers by default

[Wolfgang Grandegger <wg-5Yr1BZd7O62+XT7JhA+gdA@public.gmane.org>]

Hi Marc,

On 06/27/2011 09:39 AM, Marc Kleine-Budde wrote:
> The two options "CAN bit-timing calculation" and
> "Platform CAN drivers with Netlink support" have a "default Y". In order to
> activate them by default, change to "default y".
> 
> Signed-off-by: Marc Kleine-Budde <mkl-bIcnvbaLZ9MEGnE8C9+IrQ@public.gmane.org>
> ---
>  drivers/net/can/Kconfig |    4 ++--
>  1 files changed, 2 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/net/can/Kconfig b/drivers/net/can/Kconfig
> index bbf06f7..f1f9fd9 100644
> --- a/drivers/net/can/Kconfig
> +++ b/drivers/net/can/Kconfig
> @@ -36,7 +36,7 @@ config CAN_SLCAN
>  config CAN_DEV
>  	tristate "Platform CAN drivers with Netlink support"
>  	depends on CAN
> -	default Y
> +	default y
>  	---help---
>  	  Enables the common framework for platform CAN drivers with Netlink
>  	  support. This is the standard library for CAN drivers.
> @@ -45,7 +45,7 @@ config CAN_DEV
>  config CAN_CALC_BITTIMING
>  	bool "CAN bit-timing calculation"
>  	depends on CAN_DEV
> -	default Y
> +	default y
>  	---help---
>  	  If enabled, CAN bit-timing parameters will be calculated for the
>  	  bit-rate specified via Netlink argument "bitrate" when the device

Acked-by: Wolfgang Grandegger <wg-5Yr1BZd7O62+XT7JhA+gdA@public.gmane.org>

Ahh, ohh, a trivial fix for a long-standing problem. Would be nice if
Kbuild would report such invalid default settings.

Thanks,

Wolfgang.