HSR: How to set IF_OPER_LOWERLAYERDOWN?

Arvid Brodin
2012-06-26T22:28:53Z

Hi,

According to Documentation/networking/operstates.txt a network interface have an
operational state and an administrative state.

If I understand things correctly the administrative state is the desired state set by
userspace, and the operational state is the actual state which depends on things like the
administrative state, whether a carrier is present, or (for virtual interfaces lite VLAN)
whether the lower interface is available.

In the driver I'm writing (for the "HSR" redundancy protocol) a hsr (virtual) interface is
useable as long as any of its (physical) slaves are useable. I.e. the operstate of a hsr
device might be set like this:

void hsr_set_operstate()
{
if (!is_admin_up(hsr_dev)) /* Check IFF_UP */ {
set_operstate(hsr_dev, IF_OPER_DOWN);
return;
}

if (is_operstate_up(slave1) || is_operstate_up(slave2)) /* Check IF_OPER_UP */
set_operstate(hsr_dev, IF_OPER_UP);
else
set_operstate(hsr_dev, IF_OPER_LOWERLAYERDOWN);
}

However, the function set_operstate() (in net/core/rtnetlink.c) only accept transitions to
IF_OPER_UP and IF_OPER_DORMANT - other transitions are ignored. (There is a function
rfc2863_policy() (net/core/link_watch.c) that may return IF_OPER_LOWERLAYERDOWN iff
(!netif_carrier_ok(dev) && (dev->ifindex != dev->iflink)), but I don't know what that means.)

So how do I signal my interface as being IF_OPER_LOWERLAYERDOWN?

In another, related matter, I'm wondering if I should set the carrier state of my virtual
interface so that it shows netif_carrier_ok() when it is possible to get the interface to
IF_OPER_UP:

void hsr_set_carrier()
{
if (is_operstate_up(slave1) || is_operstate_up(slave2))
netif_carrier_on(hsr_dev);
else
netif_carrier_off(hsr_dev);
}

Thanks,
--
Arvid Brodin | Consultant (Linux)
XDIN AB | Jan Stenbecks Torg 17 | SE-164 40 Kista | Sweden | xdin.com