Re: [PATCH v2 2/2] ARM: at91/dt: define phy available on sama5d3 mother board

[boris brezillon <b.brezillon@overkiz.com>]

Hello Sergei,

On 26/08/2013 15:21, Sergei Shtylyov wrote:
> Hello.
>
> On 26-08-2013 16:35, Boris BREZILLON wrote:
>
>> This patch describe the phy used on atmel sama5d3 mother board:
>>   - phy address
>>   - phy interrupt pin
>
>> Signed-off-by: Boris BREZILLON <b.brezillon@overkiz.com>
>> ---
>>   arch/arm/boot/dts/sama5d3xmb.dtsi |    8 ++++++++
>>   1 file changed, 8 insertions(+)
>
>> diff --git a/arch/arm/boot/dts/sama5d3xmb.dtsi 
>> b/arch/arm/boot/dts/sama5d3xmb.dtsi
>> index 8a9e05d..e9521d5 100644
>> --- a/arch/arm/boot/dts/sama5d3xmb.dtsi
>> +++ b/arch/arm/boot/dts/sama5d3xmb.dtsi
>> @@ -81,6 +81,14 @@
>>
>>               macb1: ethernet@f802c000 {
>>                   phy-mode = "rmii";
>> +
>> +                #address-cells = <1>;
>> +                #size-cells = <0>;
>> +                phy0: ethernet-phy@0 {
>
>    Address part of the node name doesn't match the "reg" property.

Indeed, I based my definition on arch/arc/boot/dts/angel4.dts where phy 
is registered like this :

             phy0: ethernet-phy@0 {
                 reg = <1>;
             };

I think it's buggy there too, because I checked other dts files and they 
all put the same address
after @ and in reg register.

I'll fix this fot the next version.

Thanks

Best Regards,
Boris



>
>> +                    interrupt-parent = <&pioE>;
>> +                    interrupts = <30 IRQ_TYPE_EDGE_FALLING>;
>> +                    reg = <1>;
>> +                };
>
> WBR, Sergei
>