Re: [PATCH] net: sched: tbf: fix calculation of max_size

[Yang Yingliang <yangyingliang@huawei.com>]

On 2013/11/25 20:22, David Laight wrote:
>> From: Yang Yingliang <yangyingliang@huawei.com>
>>
>> Current max_size is caluated from rate table. Now, the rate table
>> has been replaced and it's wrong to caculate max_size based on this
>> rate table. It can lead wrong calculation of max_size.
>>
>> The burst in kernel may be lower than user asked, because burst may gets
>> some loss when transform it to buffer(E.g. "burst 40kb rate 30mbit/s")
>> and it seems we cannot avoid this loss. And burst's value(max_size) based
>> on rate table may be equal user asked. If a packet's length is max_size,
>> this packet will be stalled in tbf_dequeue() because its length is above
>> the burst in kernel so that it cannot get enough tokens. The max_size guards
>> against enqueuing packet sizes above q->buffer "time" in tbf_enqueue().
> 
> Why not adjust the calculations so that the number of allocated tokens
> can go negative?
> 
> So allow the transfer if the number of tokens is +ve and then subtract
> the number needed for the message itself.

Thanks for your advice!
I had considered it before. But, I think that we calculate tokens from ns
but max_size is calculated based on rate table causes the problem. I think we
should make them consistent.

> 
> I think this would change the semantics of the configured 'burst' value
> very slightly (to 'at least' from 'at most') but the average would still
> be correct.

Hmm, I'm not sure it is 'at least'. Maybe it could be lower.

Regards,
Yang

> 
> FWIW I've done similar rate limiters that run directly in units of 'time'.
> The fact that system time advances automatically generates credit.
> 
> 	David
> 
>