Re: [PATCH] net: macb: Add big endian CPU support

[Michal Simek <monstr@monstr.eu>]

[-- Attachment #1: Type: text/plain, Size: 3249 bytes --]

On 02/24/2015 08:39 AM, Arun Chandran wrote:
> This patch converts all __raw_readl and __raw_writel function calls
> to their corresponding readl_relaxed and writel_relaxed variants.
> 
> It also tells the driver to set ahb_endian_swp_mgmt_en bit in dma_cfg
> when the cpu is configured in big endian mode.
> 
> Signed-off-by: Arun Chandran <achandran@mvista.com>
> ---
> 	This patch is tested on xilinx ZC702 evaluation board with
> 	CONFIG_CPU_BIG_ENDIAN=y and booting NFS rootfs
> 	Added on the fly IP endianness detection according to
> 	comments from Michal Simek.
> ---
> ---
>  drivers/net/ethernet/cadence/macb.c | 33 +++++++++++++++++++++++++++------
>  drivers/net/ethernet/cadence/macb.h | 15 ++++++++-------
>  2 files changed, 35 insertions(+), 13 deletions(-)
> 
> diff --git a/drivers/net/ethernet/cadence/macb.c b/drivers/net/ethernet/cadence/macb.c
> index ad76b8e..1642911 100644
> --- a/drivers/net/ethernet/cadence/macb.c
> +++ b/drivers/net/ethernet/cadence/macb.c
> @@ -449,7 +449,7 @@ static void macb_update_stats(struct macb *bp)
>  	WARN_ON((unsigned long)(end - p - 1) != (MACB_TPF - MACB_PFR) / 4);
>  
>  	for(; p < end; p++, reg++)
> -		*p += __raw_readl(reg);
> +		*p += readl_relaxed(reg);
>  }
>  
>  static int macb_halt_tx(struct macb *bp)
> @@ -1578,6 +1578,7 @@ static u32 macb_dbw(struct macb *bp)
>  static void macb_configure_dma(struct macb *bp)
>  {
>  	u32 dmacfg;
> +	u32 tmp, ncr;
>  
>  	if (macb_is_gem(bp)) {
>  		dmacfg = gem_readl(bp, DMACFG) & ~GEM_BF(RXBS, -1L);
> @@ -1585,7 +1586,25 @@ static void macb_configure_dma(struct macb *bp)
>  		if (bp->dma_burst_length)
>  			dmacfg = GEM_BFINS(FBLDO, bp->dma_burst_length, dmacfg);
>  		dmacfg |= GEM_BIT(TXPBMS) | GEM_BF(RXBMS, -1L);
> -		dmacfg &= ~GEM_BIT(ENDIA);
> +		dmacfg &= ~GEM_BIT(ENDIA_PKT);
> +
> +		/* Here we use the loopback bit of net_ctrl register to detect
> +		 * endianness on IP. save it first. Program swaped mode for
> +		 * management descriptor accesses if writing to loop back bit
> +		 * and reading it back brings no change in bit value.
> +		 */
> +		ncr = macb_readl(bp, NCR);
> +		__raw_writel(MACB_BIT(LLB), bp->regs + MACB_NCR);
> +		tmp =  __raw_readl(bp->regs + MACB_NCR);


I have tested this patch on zc702 le and be and it is working.
The comment is not fully accurate. Sorry I thought that you are using a little bit different
configuration than Zynq. The case I had in mind is that CPU and also IP can have different endianness.

The code above is not checking endianness on IP itself but CPU endianness because IP is in little
endian mode all the time. But the logic for detecting this on CPU is correct and this is what
you need to do on Zynq. You are writing big endian value to little endian register and read it back
to see if it was correctly written or not.

Can you please fix that comment to reflect this?

Thanks,
Michal
-- 
Michal Simek, Ing. (M.Eng), OpenPGP -> KeyID: FE3D1F91
w: www.monstr.eu p: +42-0-721842854
Maintainer of Linux kernel - Microblaze cpu - http://www.monstr.eu/fdt/
Maintainer of Linux kernel - Xilinx Zynq ARM architecture
Microblaze U-BOOT custodian and responsible for u-boot arm zynq platform



[-- Attachment #2: OpenPGP digital signature --]
[-- Type: application/pgp-signature, Size: 198 bytes --]