Re: [PATCH RFC 1/2] net: dsa: integrate with SWITCHDEV for HW bridging

[Andrey Volkov <andrey.volkov@nexvision.fr>]

On 02/03/2015 15:49, Guenter Roeck wrote:
> On 03/02/2015 06:38 AM, Andrey Volkov wrote:
>>
>> On 28/02/2015 08:53, Guenter Roeck wrote:
>>> On 02/27/2015 09:09 AM, Andrey Volkov wrote:
>>>> Gunter,
>>>>
>>>> Sorry with response delay, I very was busy yesterday
>>>>
>>>> Le 25/02/2015 15:25, Guenter Roeck a écrit :
>>>>> Andrey,
>>>>
>>>> ------- snip -------
>>>>
>>>>>>>
>>>>>> I simply modify port's fid to the new one in the leave routine and set to common bridge FID in enter
>>>>>> (I'm using Marvell's chips). So the port's database will cleaned up automatically for the leave and will
>>>>>> contain something useful at the enter time. Also I've look through yours patches and I haven't
>>>>>
>>>>> Does removing a port from a fid clean up the entries associated with it
>>>>> in the database ?
>>>>
>>>> I've checked what happened when port changed its FID: switch logic block traffic to it
>>>> immediately, as far as I can see, meanwhile record still exists in the bridge database,
>>>> it was checked on 88e6185, 88e6097 and 88e6352 chips. And yet another 5c: changing of group membership is
>>>> not atomic operation in the Marvell's chips known for me, so the port must be in the disabled state when it
>>>> will happened.
>>>>
>>> Hmm - interesting. I assume you mean updating port registers 5 and 6 ?
>> Yes sure, it's reason why we must disable the port before changing the FID.
>>
> Yes, I think we'll need to do that once we use the bits in register 5.
> 
>>>
>>> Different question: For 6185, did you write a new driver or extend an existing one ?
>>> I found that it is quite similar to 6131, and that adding support for it to the 6131
>>> driver should be straightforward.
>> Yes again :), and 88E6097 have same core as 6123_61_65. Difference in both cases only in the number
>> of supported ports, and it was main reason why hardcoded port's number was unacceptable for me, difference is
>> large enough: for ex. 88e6123 have only 3 ports, but 88E6097 - 11.
>>
> 
> I have a patch set to change the number of ports to a variable in the 6131 driver.
> Want me to submit it now ? Though I guess you must have pretty much the same,
> so we can also use your approach. Let me know.

I think that better to start from my patches: they are more generic and have support of sysfs
(should be useful for "MII over ethernet"). Also IMO it will be better if we continue exchange/prereview
our patches in more narrow mail list, since I do not want to pollute netdev by useless discussions about drafts.
Objections/suggestions?

--
Regards
Andrey