Re: [PATCH net] mpls: fix mpls route deletes to not check for route scope and type

[roopa <roopa@cumulusnetworks.com>]

On 5/26/15, 2:48 PM, Eric W. Biederman wrote:
> Roopa Prabhu <roopa@cumulusnetworks.com> writes:
>
>> From: Roopa Prabhu <roopa@cumulusnetworks.com>
>>
>> This patch fixes incorrect -EINVAL error due to invalid
>> scope and type for mpls route deletes.
> Well this is embarrassing apparently I did not exercise this code path
> in iproute.
>
> Looking through my tests the closest I came was:
> ip -M route flush table all
>
>> iproute2 route modify code does not set protocol/scope/type
>> for RTM_DELROUTE msgs. mpls code can skip checking for
>> these too.
> I am really not certain that is the case.  I expect if you check
> you will find that rtm_scope is set to 0  aka RT_SCOPE_UNIVERSE.
>
> For scope I don't much care.  The mpls concepts and the ip concepts
> don't match.  With mpls packets can be sent from anywhere in the
> universe to an address that is valid only on one link.
>
> For rtm_type I think we do care.  IPv4 and IPv6 are a disaster when it
> comes to interfaces for setting up multicast routes, and I don't see any
> reason why we would need to replicate that disaster for mpls.
>
> As such I would like rtm_type to actually mean something, as for mpls
> the lookup for multicast packets and the lookup for unicast packets is
> completely different.  Unicast packet addresses are defined by the
> receiver, and multicast packet addresses are defined by the sender.
>
> So can we instead fix iproute to set rtm_type == RTN_UNICAST?
> At least for mpls.
>
>
yes sure. I started with handling this in iproute2. So, i do have an 
iproute2 patch for this.
Will post it later today.

thanks.