Re: [PATCH net v3 0/5] drivers: net: cpsw: phy-handle fixes

[Grygorii Strashko <grygorii.strashko@ti.com>]

On 04/28/2016 04:10 AM, David Rivshin (Allworx) wrote:
> From: David Rivshin <drivshin@allworx.com>
>
> This series fixes a number of related issues around using phy-handle
> properties in cpsw emac nodes.
>
> Patch 1 fixes a bug if more than one slave is used, and either
> slave uses the phy-handle property in the devicetree.
>
> Patch 2 fixes a NULL pointer dereference which can occur if a
> phy-handle property is used and of_phy_connect() return NULL,
> such as with a bad devicetree.
>
> Patch 3 fixes an issue where the phy-mode property would be ignored
> if a phy-handle property was used. This also fixes a bogus error
> message that would be emitted.
>
> Patch 4 fixes makes the binding documentation more explicit that
> exactly one PHY property should be used, and also marks phy_id as
> deprecated.
>
> Patch 5 cleans up the fixed-link case to work like the now-fixed
> phy-handle case.
>
> I have tested on the following hardware configurations:
>   - (EVMSK) dual emac, phy_id property in both slaves
>   - (EVMSK) dual emac, phy-handle property in both slaves
>   - (EVMSK) a bad phy-handle property pointing to &mmc1
>   - (EVMSK) phy_id property with incorrect PHY address
>   - (BeagleBoneBlack) single emac, phy_id property
>   - (custom) single emac, fixed-link subnode
>
> Andrew Goodbody reported testing v2 on a board that doesn't use
> dual_emac mode, but with 2 PHYs using phy-handle properties [1].
>
> Nicolas Chauvet reported testing v2 on an HP t410 (dm8148).
>
> Markus Brunner reported testing v1 on the following [2]:
>   - emac0 with phy_id and emac1 with fixed phy
>   - emac0 with phy-handle and emac1 with fixed phy
>   - emac0 with fixed phy and emac1 with fixed phy
>
> [1] https://lkml.org/lkml/2016/4/22/537
> [2] http://www.spinics.net/lists/netdev/msg357890.html
>
> David Rivshin (5):
>    drivers: net: cpsw: fix parsing of phy-handle DT property in dual_emac
>      config
>    drivers: net: cpsw: fix segfault in case of bad phy-handle
>    drivers: net: cpsw: don't ignore phy-mode if phy-handle is used
>    dt: cpsw: phy-handle, phy_id, and fixed-link are mutually exclusive
>    drivers: net: cpsw: use of_phy_connect() in fixed-link case
>
>   Documentation/devicetree/bindings/net/cpsw.txt |  6 +--
>   drivers/net/ethernet/ti/cpsw.c                 | 69 ++++++++++++++------------
>   drivers/net/ethernet/ti/cpsw.h                 |  1 +
>   3 files changed, 41 insertions(+), 35 deletions(-)
>

Thanks a lot.
Reviewed-by: Grygorii Strashko <grygorii.strashko@ti.com>

-- 
regards,
-grygorii