From: Jay Vosburgh <jay.vosburgh@canonical.com>
To: Mahesh Bandewar <maheshb@google.com>
Cc: Veaceslav Falico <vfalico@redhat.com>,
Andy Gospodarek <andy@greyhouse.net>,
David Miller <davem@davemloft.net>,
netdev <netdev@vger.kernel.org>,
Eric Dumazet <edumazet@google.com>,
Maciej Zenczykowski <maze@google.com>
Subject: Re: [PATCH] bonding: Do not try to send packets over dead link in TLB mode.
Date: Thu, 10 Jul 2014 06:39:30 -0700 [thread overview]
Message-ID: <7156.1404999570@localhost.localdomain> (raw)
In-Reply-To: <1404868198-24839-1-git-send-email-maheshb@google.com>
Mahesh Bandewar <maheshb@google.com> wrote:
>In TLB mode if tlb_dynamic_lb is NOT set, slaves from the bond
>group are selected based on the hash distribution. This does not
>exclude dead links which are part of the bond. Also if there is a
>temporary link event which brings down the interface, packets
>hashed on that interface would be dropped too.
>
>This patch fixes these issues and distributes flows across the
>UP links only. Also the array construction of links which are
>capable of sending packets happen in the control path leaving
>only link-selection duing the data-path.
>
>One possible side effect of this is - at a link event; all
>flows will be shuffled to get good distribution. But impact of
>this should be minimum with the assumption that a member or
>members of the bond group are not available is a very temporary
>situation.
Why limit this to just TLB mode? Other similar situations,
e.g., the TX slave selection in 802.3ad or balance-xor via
bond_xmit_slave_id, would presumably see a performance gain from using
an array lookup instead of traversing a linked list (even though those
modes do already skip slaves that are down).
The 802.3ad case is a bit more complex, as an array would have
to include only slaves that are members of the active aggregator, but
the bond_xmit_slave_id case shouldn't be much more difficult than what
you've done below.
-J
>Signed-off-by: Mahesh Bandewar <maheshb@google.com>
>---
> drivers/net/bonding/bond_alb.c | 52 +++++++++++++++++++++++++++++++++++++-----
> drivers/net/bonding/bond_alb.h | 11 +++++++++
> drivers/net/bonding/bonding.h | 6 +++++
> 3 files changed, 63 insertions(+), 6 deletions(-)
>
>diff --git a/drivers/net/bonding/bond_alb.c b/drivers/net/bonding/bond_alb.c
>index 76c0dade233f..1f39d41fde4b 100644
>--- a/drivers/net/bonding/bond_alb.c
>+++ b/drivers/net/bonding/bond_alb.c
>@@ -195,6 +195,9 @@ static int tlb_initialize(struct bonding *bond)
>
> _unlock_tx_hashtbl_bh(bond);
>
>+ /* Initialize the TLB array spin-lock */
>+ spin_lock_init(&bond_info->slave_arr_lock);
>+
> return 0;
> }
>
>@@ -209,6 +212,9 @@ static void tlb_deinitialize(struct bonding *bond)
> bond_info->tx_hashtbl = NULL;
>
> _unlock_tx_hashtbl_bh(bond);
>+
>+ if (bond_is_nondyn_tlb(bond) && bond_info->slave_arr)
>+ kfree_rcu(bond_info->slave_arr, rcu);
> }
>
> static long long compute_gap(struct slave *slave)
>@@ -1406,9 +1412,37 @@ out:
> return NETDEV_TX_OK;
> }
>
>+static int bond_tlb_update_slave_arr(struct bonding *bond)
>+{
>+ struct alb_bond_info *bond_info = &(BOND_ALB_INFO(bond));
>+ struct slave *tx_slave;
>+ struct list_head *iter;
>+ struct tlb_up_slave *new_arr, *old_arr;
>+
>+ new_arr = kzalloc(offsetof(struct tlb_up_slave, arr[bond->slave_cnt]),
>+ GFP_KERNEL);
>+ if (!new_arr)
>+ return -ENOMEM;
>+
>+ bond_for_each_slave(bond, tx_slave, iter) {
>+ if (bond_slave_can_tx(tx_slave))
>+ new_arr->arr[new_arr->count++] = tx_slave;
>+ }
>+
>+ spin_lock(&bond_info->slave_arr_lock);
>+ old_arr = bond_info->slave_arr;
>+ rcu_assign_pointer(bond_info->slave_arr, new_arr);
>+ spin_unlock(&bond_info->slave_arr_lock);
>+ if (old_arr)
>+ kfree_rcu(old_arr, rcu);
>+
>+ return 0;
>+}
>+
> int bond_tlb_xmit(struct sk_buff *skb, struct net_device *bond_dev)
> {
> struct bonding *bond = netdev_priv(bond_dev);
>+ struct alb_bond_info *bond_info = &(BOND_ALB_INFO(bond));
> struct ethhdr *eth_data;
> struct slave *tx_slave = NULL;
> u32 hash_index;
>@@ -1429,12 +1463,13 @@ int bond_tlb_xmit(struct sk_buff *skb, struct net_device *bond_dev)
> hash_index & 0xFF,
> skb->len);
> } else {
>- struct list_head *iter;
>- int idx = hash_index % bond->slave_cnt;
>-
>- bond_for_each_slave_rcu(bond, tx_slave, iter)
>- if (--idx < 0)
>- break;
>+ struct tlb_up_slave *slaves;
>+ rcu_read_lock();
>+ slaves = rcu_dereference(bond_info->slave_arr);
>+ if (slaves && slaves->count)
>+ tx_slave = slaves->arr[hash_index %
>+ slaves->count];
>+ rcu_read_unlock();
> }
> break;
> }
>@@ -1721,6 +1756,11 @@ void bond_alb_handle_link_change(struct bonding *bond, struct slave *slave, char
> */
> }
> }
>+
>+ if (bond_is_nondyn_tlb(bond)) {
>+ if (bond_tlb_update_slave_arr(bond))
>+ pr_err("Failed to build slave-array for TLB mode.\n");
>+ }
> }
>
> /**
>diff --git a/drivers/net/bonding/bond_alb.h b/drivers/net/bonding/bond_alb.h
>index 5fc76c01636c..731a8e830639 100644
>--- a/drivers/net/bonding/bond_alb.h
>+++ b/drivers/net/bonding/bond_alb.h
>@@ -139,12 +139,23 @@ struct tlb_slave_info {
> */
> };
>
>+struct tlb_up_slave {
>+ unsigned int count;
>+ struct rcu_head rcu;
>+ struct slave *arr[0];
>+};
>+
> struct alb_bond_info {
> struct tlb_client_info *tx_hashtbl; /* Dynamically allocated */
> spinlock_t tx_hashtbl_lock;
> u32 unbalanced_load;
> int tx_rebalance_counter;
> int lp_counter;
>+ /* -------- non-dynamic tlb mode only ---------*/
>+ struct tlb_up_slave __rcu *slave_arr; /* Up slaves */
>+ spinlock_t slave_arr_lock; /* Lock to manage concurrent
>+ * writers
>+ */
> /* -------- rlb parameters -------- */
> int rlb_enabled;
> struct rlb_client_info *rx_hashtbl; /* Receive hash table */
>diff --git a/drivers/net/bonding/bonding.h b/drivers/net/bonding/bonding.h
>index 0b4d9cde0b05..ad9b3dce07d8 100644
>--- a/drivers/net/bonding/bonding.h
>+++ b/drivers/net/bonding/bonding.h
>@@ -265,6 +265,12 @@ static inline bool bond_is_lb(const struct bonding *bond)
> BOND_MODE(bond) == BOND_MODE_ALB;
> }
>
>+static inline bool bond_is_nondyn_tlb(const struct bonding *bond)
>+{
>+ return (BOND_MODE(bond) == BOND_MODE_TLB) &&
>+ (bond->params.tlb_dynamic_lb == 0);
>+}
>+
> static inline bool bond_mode_uses_arp(int mode)
> {
> return mode != BOND_MODE_8023AD && mode != BOND_MODE_TLB &&
>--
>2.0.0.526.g5318336
---
-Jay Vosburgh, jay.vosburgh@canonical.com
next prev parent reply other threads:[~2014-07-10 13:39 UTC|newest]
Thread overview: 17+ messages / expand[flat|nested] mbox.gz Atom feed top
2014-07-09 1:09 [PATCH] bonding: Do not try to send packets over dead link in TLB mode Mahesh Bandewar
2014-07-09 7:10 ` Eric Dumazet
[not found] ` <CAF2d9jh1jDL7NMZapGn_Ohy8Y2JzHrWaKA5gFgR0tU=_KydtPg@mail.gmail.com>
2014-07-09 17:09 ` Eric Dumazet
2014-07-09 17:21 ` Mahesh Bandewar
2014-07-09 10:14 ` Nikolay Aleksandrov
2014-07-09 10:24 ` Veaceslav Falico
2014-07-09 10:25 ` Nikolay Aleksandrov
2014-07-09 12:04 ` Veaceslav Falico
2014-07-09 13:17 ` Eric Dumazet
2014-07-09 13:27 ` Veaceslav Falico
2014-07-09 17:15 ` Mahesh Bandewar
2014-07-09 17:24 ` Mahesh Bandewar
2014-07-09 21:07 ` Nikolay Aleksandrov
2014-07-10 8:25 ` Maciej Żenczykowski
2014-07-09 16:52 ` Mahesh Bandewar
2014-07-10 13:39 ` Jay Vosburgh [this message]
2014-07-10 14:40 ` Mahesh Bandewar
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=7156.1404999570@localhost.localdomain \
--to=jay.vosburgh@canonical.com \
--cc=andy@greyhouse.net \
--cc=davem@davemloft.net \
--cc=edumazet@google.com \
--cc=maheshb@google.com \
--cc=maze@google.com \
--cc=netdev@vger.kernel.org \
--cc=vfalico@redhat.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).