Re: [PATCH] net: mvpp2: add delay at the end of .mac_prepare

[Baruch Siach <baruch@tkos.co.il>]

Hi Marcin,

On Thu, Apr 28 2022, Marcin Wojtas wrote:
> śr., 27 kwi 2022 o 17:05 Baruch Siach <baruch@tkos.co.il> napisał(a):
>>
>> From: Baruch Siach <baruch.siach@siklu.com>
>>
>> Without this delay PHY mode switch from XLG to SGMII fails in a weird
>> way. Rx side works. However, Tx appears to work as far as the MAC is
>> concerned, but packets don't show up on the wire.
>>
>> Tested with Marvell 10G 88X3310 PHY.
>>
>> Signed-off-by: Baruch Siach <baruch.siach@siklu.com>
>> ---
>>
>> Not sure this is the right fix. Let me know if you have any better
>> suggestion for me to test.
>>
>> The same issue and fix reproduce with both v5.18-rc4 and v5.10.110.
>> ---
>>  drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c | 2 ++
>>  1 file changed, 2 insertions(+)
>>
>> diff --git a/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c b/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c
>>n index 1a835b48791b..8823efe396b1 100644
>> --- a/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c
>> +++ b/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c
>> @@ -6432,6 +6432,8 @@ static int mvpp2_mac_prepare(struct phylink_config *config, unsigned int mode,
>>                 }
>>         }
>>
>> +       mdelay(10);
>> +
>>         return 0;
>>  }
>
> Thank you for the patch and debug effort, however at first glance it
> seems that adding delay may be a work-around and cover an actual root
> cause (maybe Russell will have more input here).

That's my suspicion as well.

> Can you share exact reproduction steps?

I think I covered all relevant details. Is there anything you find
missing?

The hardware setup is very similar to the Macchiatobin Doubleshot. I can
try to reproduce on that platform next week if it helps.

The PHY MAC type (MV_V2_33X0_PORT_CTRL_MACTYPE_MASK) is set to
MV_V2_33X0_PORT_CTRL_MACTYPE_10GBASER.

I can add that DT phy-mode is set to "10gbase-kr" (equivalent to
"10gbase-r" in this case). The port cp0_eth0 is connected to a 1G
Ethernet switch. Kernel messages indicate that on interface up the MAC
is first configured to XLG (10G), but after Ethernet (wire)
auto-negotiation that MAC switches to SGMII. If I set DT phy-mode to
"sgmii" the issue does not show. Same if I make a down/up cycle of the
interface.

Thanks for your review.

baruch

-- 
                                                     ~. .~   Tk Open Systems
=}------------------------------------------------ooO--U--Ooo------------{=
   - baruch@tkos.co.il - tel: +972.52.368.4656, http://www.tkos.co.il -