From: "Toke Høiland-Jørgensen" <toke@toke.dk>
To: Jamal Hadi Salim <jhs@mojatatu.com>, netdev@vger.kernel.org
Cc: "Jamal Hadi Salim" <jhs@mojatatu.com>,
"Björn Töpel" <bjorn@kernel.org>, "Jiri Pirko" <jiri@resnulli.us>,
"David S . Miller" <davem@davemloft.net>,
"Eric Dumazet" <edumazet@kernel.org>,
"Jakub Kicinski" <kuba@kernel.org>,
"Paolo Abeni" <pabeni@redhat.com>,
"Simon Horman" <horms@kernel.org>,
cake@lists.bufferbloat.net,
"Victor Nogueira" <victor@mojatatu.com>,
Sashiko <sashiko-bot@kernel.org>
Subject: Re: [PATCH net-next v3 1/4] net/sched/sch_cake: serialize reconfiguration with the datapath
Date: Tue, 20 Oct 2026 14:49:57 +0200 [thread overview]
Message-ID: <87wlrctu2y.fsf@toke.dk> (raw)
In-Reply-To: <QDISC-5RTM.v3.r0.20261020053711-1@mojatatu.com>
Jamal Hadi Salim <jhs@mojatatu.com> writes:
> This is a follow-up to commit 7cbfb180945c ("net/sched: sch_cake: fix
> autorate reconfiguration throttling"). That change only stored
> last_reconfig_time; it did not address the concurrency between the
> autorate rate update in cake_enqueue() and the netlink reconfiguration
> path, which the original review flagged.
>
> The issue:
> cake_change() -> cake_config_change() updates the fields of the shared
> struct cake_sched_config under RTNL but not under the qdisc lock: it only
> took sch_tree_lock() later, around cake_reconfigure(). The datapath in
> turn serializes cake_enqueue() with itself under the qdisc lock, and its
> autorate-ingress path stores the estimated rate into
> q->config->rate_bps. Two writers therefore update the same rate with no
> common lock:
>
> CPU0: cake_enqueue() sees CAKE_FLAG_AUTORATE_INGRESS, computes an
> estimate, and is about to store it.
> CPU1: 'tc qdisc change ... bandwidth X' clears autorate in its local
> rate_flags, writes rate_bps = X, publishes the cleared flag, and
> waits in sch_tree_lock().
> CPU0: stores the estimate, calls cake_reconfigure(), and unlocks.
> CPU1: reconfigures from the estimate and returns.
>
> The qdisc is left with autorate disabled but with the estimate installed
> instead of X.
>
> The fix:
> Commit the parsed configuration and reconfigure while holding the same
> qdisc lock that serializes the datapath, so the netlink writer and the
> autorate writer can no longer interleave. rate_bps needs no atomic: it is
> only ever loaded and stored, so plain READ_ONCE()/WRITE_ONCE() annotations
> are enough for the accesses that run outside the lock. The lockless
> paths read the rate once into a local and reuse that value, so a single
> coherent snapshot is used per operation.
>
> The annotations do not make a 64-bit access single-copy atomic on 32-bit:
> READ_ONCE()/WRITE_ONCE() are still two 32-bit accesses there. The lockless
> readers -- cake_config_dump() and the cake_mq children, which observe the
> shared config under a different child's lock -- can therefore still see a
> torn rate on 32-bit. That rate is an advisory shaper value and is accepted
> as best-effort; the state that must be consistent (the configured rate and
> the autorate flag) is written under the qdisc lock.
>
> Conditions to recreate the bug:
> The lost update (a) needs no sanitizer. Put cake in autorate-ingress on a
> device, drive bursty traffic with gaps so the 250 ms autorate reconfiguration
> fires, and concurrently loop 'tc qdisc change ... cake bandwidth <N>kbit'
> without autorate-ingress (specifying a bandwidth clears the flag).
> If the autorate store lands after the change wrote its rate but before the
> change reconfigures, the qdisc ends up with autorate disabled and the estimate
> installed instead of <N>; reading the rate back then shows the estimate, which
> an unfixed kernel can do and a fixed one cannot.
> (b) The unsynchronized access is reported by KCSAN: build with CONFIG_KCSAN=y
> and run the same trigger with the change loop keeping autorate-ingress set;
> KCSAN reports a data race in cake_config_change / cake_enqueue.
> The non-atomic 64-bit store only shows up as tearing on a 32-bit machine;
> on 64-bit the store is atomic and KCSAN flags the access discipline instead.
>
> Reported-by: Sashiko (gemini) <sashiko-bot@kernel.org>
> Link: https://sashiko.dev/#/patchset/20260816012109.2865223-1-ooonea@gmail.com
> Link: https://lore.kernel.org/netdev/20260816012109.2865223-1-ooonea@gmail.com/
> Link: https://lore.kernel.org/netdev/875wzctsky.fsf@toke.dk/
> Link: https://lore.kernel.org/netdev/87ld7t3kl3.fsf@all.your.base.are.belong.to.us/
> Reviewed-by: Victor Nogueira <victor@mojatatu.com>
> Signed-off-by: Jamal Hadi Salim <jhs@mojatatu.com>
Acked-by: Toke Høiland-Jørgensen <toke@toke.dk>
prev parent reply other threads:[~2026-10-20 12:50 UTC|newest]
Thread overview: 7+ messages / expand[flat|nested] mbox.gz Atom feed top
2026-10-20 11:00 [PATCH net-next v3 0/4] net/sched: sch_cake: fixes for accounting and reconfiguration Jamal Hadi Salim
2026-10-20 11:00 ` [PATCH net-next v3 1/4] net/sched/sch_cake: serialize reconfiguration with the datapath Jamal Hadi Salim
2026-10-20 11:00 ` [PATCH net-next v3 2/4] net/sched/sch_cake: reduce parent backlog when clearing a tin Jamal Hadi Salim
2026-10-20 11:00 ` [PATCH net-next v3 3/4] net/sched/sch_cake: widen buffer_used to u64 Jamal Hadi Salim
2026-10-20 11:00 ` [PATCH net-next v3 4/4] net/sched/sch_cake: drop dead nla_nest_end() error check Jamal Hadi Salim
2026-10-20 12:55 ` [PATCH net-next v3 3/4] net/sched/sch_cake: widen buffer_used to u64 Toke Høiland-Jørgensen
2026-10-20 12:49 ` Toke Høiland-Jørgensen [this message]
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=87wlrctu2y.fsf@toke.dk \
--to=toke@toke.dk \
--cc=bjorn@kernel.org \
--cc=cake@lists.bufferbloat.net \
--cc=davem@davemloft.net \
--cc=edumazet@kernel.org \
--cc=horms@kernel.org \
--cc=jhs@mojatatu.com \
--cc=jiri@resnulli.us \
--cc=kuba@kernel.org \
--cc=netdev@vger.kernel.org \
--cc=pabeni@redhat.com \
--cc=sashiko-bot@kernel.org \
--cc=victor@mojatatu.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox