messages from 2026-07-26 09:46:14 to 2026-07-26 18:15:20 UTC [more...]
[PATCH] net: stmmac: enable MAC rx/tx after DMA start
2026-07-26 18:15 UTC (2+ messages)
[PATCH net] net/x25: fix use-after-free of the socket by its timers
2026-07-26 17:04 UTC (2+ messages)
[GIT PULL] wireless-next-2026-07-26
2026-07-26 17:03 UTC (2+ messages)
[PATCH net] net: bridge: mrp: fix uninitialised bytes on the wire
2026-07-26 17:00 UTC (3+ messages)
[PATCH net] net: phylink: put link_gpio if phylink_create fails
2026-07-26 16:50 UTC (2+ messages)
[PATCH net-next v9 0/3] net: dsa: motorcomm: Add LED support
2026-07-26 16:27 UTC (4+ messages)
` [PATCH net-next v9 1/3] net: dsa: motorcomm: Move to subdirectory
` [PATCH net-next v9 2/3] net: dsa: motorcomm: Split SMI module
` [PATCH net-next v9 3/3] net: dsa: motorcomm: Add LED support
[PATCH 2/3] AF_ALG: Drop support for off-CPU cryptography
2026-07-26 15:50 UTC (9+ messages)
[PATCH iproute2 v3] add print_hexstring helper
2026-07-26 15:50 UTC
[PATCH net] packet: use a consistent hard_header_len in send paths
2026-07-26 15:21 UTC (3+ messages)
` [PATCH net v2] packet: use consistent header lengths in raw "
[PATCH net-next v5] net: phy: Add driver for Motorcomm Quad 2.5GbE phy
2026-07-26 14:51 UTC (10+ messages)
[PATCH net-next v9 00/12] net: pcs: Introduce support for fwnode PCS
2026-07-26 14:33 UTC (4+ messages)
` [PATCH net-next v9 06/12] net: Document PCS subsystem
[PATCH net] net: do not send ICMP/NDISC Redirects when peer allocation fails
2026-07-26 14:06 UTC (2+ messages)
[PATCH net-next v2 0/2] net: stmmac: Fix PHY attach when custom PCS is in use
2026-07-26 13:26 UTC (3+ messages)
` [PATCH net-next v2 1/2] net: phylink: allow PHYs to be attached in 802.3z inband mode
` [PATCH net-next v2 2/2] net: stmmac: Skip PHY attach if custom PCS is in use
[PATCH net] macvlan: require lower-netns admin for shared port settings
2026-07-26 12:54 UTC
[RFC PATCH 6.6.y] atm: he: kill tasklet before releasing queues
2026-07-26 12:50 UTC (3+ messages)
` "
[PATCH net 0/1] net: ipv6: clear suppressed fib6 rule result
2026-07-26 12:16 UTC (3+ messages)
` [PATCH net 1/1] "
[PATCH net] netdevsim: tc: serialize access to nsim_block_cb_list
2026-07-26 12:03 UTC (2+ messages)
` [PATCH net v2] net: flow_offload: serialize driver callback lists
[PATCH net-next] dt-bindings: net: fix spelling errors
2026-07-26 11:27 UTC (2+ messages)
[PATCH net-next v9 0/4] net: pse-pd: add Realtek PSE MCU support
2026-07-26 11:22 UTC (5+ messages)
` [PATCH net-next v9 1/4] dt-bindings: net: pse-pd: add bindings for Realtek PSE MCU
` [PATCH net-next v9 2/4] net: pse-pd: add Realtek PSE MCU core
` [PATCH net-next v9 3/4] net: pse-pd: realtek-pse-mcu: add I2C transport
` [PATCH net-next v9 4/4] net: pse-pd: realtek-pse-mcu: add UART transport
[PATCH net-next 0/5] bridge: Validate and clean up IPv6 neighbour suppression
2026-07-26 11:03 UTC (4+ messages)
` [PATCH net-next 4/5] bridge: Linearize skb once the ND message type is validated
[PATCH net 0/2] tls: fix plaintext sk_msg ring over-fill in tls_sw_sendmsg_splice()
2026-07-26 10:55 UTC (3+ messages)
` [PATCH net 1/2] tls: don't over-fill the plaintext sk_msg ring "
` [PATCH net 2/2] selftests: tls: add a test for splicing onto a full plaintext record
[PATCH 0/3] usb: Use %pe to print error pointers
2026-07-26 10:54 UTC (4+ messages)
` [PATCH 1/3] usb: chipidea: "
[PATCH 1/1] qede: sync udp_tunnel ports outside qede_lock in the recovery path
2026-07-26 10:43 UTC
[PATCH net 0/5] vxlan: fixes for skb header pulling, cloning, and concurrency in TX path
2026-07-26 10:34 UTC (3+ messages)
` [PATCH net 5/5] vxlan: use pskb_network_may_pull() for transmit path header pulls
[PATCH net 0/1] net: bridge: fix fast-leave use-after-free
2026-07-26 10:13 UTC (3+ messages)
` [PATCH net 1/1] net: bridge: stop fast-leave after deleting a port group
[PATCH net-next] ipip: reject unsupported configurations in fill_forward_path
2026-07-26 9:46 UTC (2+ messages)
page: | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox