[patch 10/16] net/mac89x0: replace schedule_timeout() with msleep()

[patch 10/16] net/mac89x0: replace schedule_timeout() with msleep()

[janitor]

I would appreciate any comments from the janitor@sternweltens list. This is one (of
many) cases where I made a decision about replacing

set_current_state(TASK_INTERRUPTIBLE);
schedule_timeout(some_time);

with

msleep(jiffies_to_msecs(some_time));

msleep() is not exactly the same as the previous code, but I only did
this replacement where I thought long delays were *desired*. If this is
not the case here, then just disregard this patch. 

Thanks,
Nish



Description: Replace schedule_timeout() with msleep() to guarantee the
task delays for the desired time.

Signed-off-by: Nishanth Aravamudan <nacc@us.ibm.com>
Signed-off-by: Maximilian Attems <janitor@sternwelten.at>



---

 linux-2.6.9-rc1-bk7-max/drivers/net/mac89x0.c |    3 +--
 1 files changed, 1 insertion(+), 2 deletions(-)

diff -puN drivers/net/mac89x0.c~msleep-drivers_net_max89x0 drivers/net/mac89x0.c
--- linux-2.6.9-rc1-bk7/drivers/net/mac89x0.c~msleep-drivers_net_max89x0	2004-09-01 19:35:34.000000000 +0200
+++ linux-2.6.9-rc1-bk7-max/drivers/net/mac89x0.c	2004-09-01 19:35:34.000000000 +0200
@@ -308,8 +308,7 @@ void __init reset_chip(struct net_device
 	writereg(dev, PP_SelfCTL, readreg(dev, PP_SelfCTL) | POWER_ON_RESET);
 
 	/* wait 30 ms */
-	current->state = TASK_INTERRUPTIBLE;
-	schedule_timeout(30*HZ/1000);
+	msleep(30);
 
 	/* Wait until the chip is reset */
 	reset_start_time = jiffies;

_