Re: [PATCH] gianfar: Don't reset TBI<->SerDes link if it's already up

[Trent Piepho <tpiepho@freescale.com>]

I just realized that this patch won't apply cleanly without another patch that
I haven't sent yet.

Please ignore, I'll repost both patches as a series when I get an ack for the
one not posted yet.

On Wed, 24 Sep 2008, Trent Piepho wrote:
> The link may be up already via the chip's reset strapping, or though action
> of U-Boot, or from the last time the interface was brought up.  Resetting
> the link causes it to go down for several seconds.  This can significantly
> increase the time from power-on to DHCP completion and a device being
> accessible to the network.
>
> Signed-off-by: Trent Piepho <tpiepho@freescale.com>
> Acked-by: Andy Fleming <afleming@freescale.com>
> ---
> drivers/net/gianfar.c |    9 +++++++++
> 1 files changed, 9 insertions(+), 0 deletions(-)
>
> diff --git a/drivers/net/gianfar.c b/drivers/net/gianfar.c
> index 1a4a85b..dd7d8e5 100644
> --- a/drivers/net/gianfar.c
> +++ b/drivers/net/gianfar.c
> @@ -578,6 +578,14 @@ static void gfar_configure_serdes(struct net_device *dev)
> 	if (bus)
> 		mutex_lock(&bus->mdio_lock);
>
> +	/* If the link is already up, we must already be ok, and don't need to
> +	 * configure and reset the TBI<->SerDes link.  Maybe U-Boot configured
> +	 * everything for us?  Resetting it takes the link down and requires
> +	 * several seconds for it to come back.
> +	 */
> +	if (gfar_local_mdio_read(regs, tbipa, MII_BMSR) & BMSR_LSTATUS)
> +		goto done;
> +
> 	/* Single clk mode, mii mode off(for serdes communication) */
> 	gfar_local_mdio_write(regs, tbipa, MII_TBICON, TBICON_CLK_SELECT);
>
> @@ -588,6 +596,7 @@ static void gfar_configure_serdes(struct net_device *dev)
> 	gfar_local_mdio_write(regs, tbipa, MII_BMCR, BMCR_ANENABLE |
> 			BMCR_ANRESTART | BMCR_FULLDPLX | BMCR_SPEED1000);
>
> +	done:
> 	if (bus)
> 		mutex_unlock(&bus->mdio_lock);
> }
>