Re: [PATCH v2 net-next 4/5] drivers/net/phy: add helpers to get/set PLCA configuration

Piergiorgio Beruto
2023-01-08T23:50:32Z

On Sat, Jan 07, 2023 at 07:07:52PM +0100, Andrew Lunn wrote:
> > +/**
> > + * genphy_c45_plca_set_cfg - set PLCA configuration using standard registers
> > + * @phydev: target phy_device struct
> > + * @plca_cfg: structure containing the PLCA configuration. Fields set to -1 are
> > + * not to be changed.
> > + *
> > + * Description: if the PHY complies to the Open Alliance TC14 10BASE-T1S PLCA
> > + * Management Registers specifications, this function can be used to modify
> > + * the PLCA configuration using the standard registers in MMD 31.
> > + */
> > +int genphy_c45_plca_set_cfg(struct phy_device *phydev,
> > + const struct phy_plca_cfg *plca_cfg)
> > +{
> > + int ret;
> > + u16 val;
> > +
> > + // PLCA IDVER is read-only
> > + if (plca_cfg->version >= 0)
> > + return -EINVAL;
> > +
> > + // first of all, disable PLCA if required
> > + if (plca_cfg->enabled == 0) {
> > + ret = phy_clear_bits_mmd(phydev, MDIO_MMD_VEND2,
> > + MDIO_OATC14_PLCA_CTRL0,
> > + MDIO_OATC14_PLCA_EN);
> > +
> > + if (ret < 0)
> > + return ret;
> > + }
> > +
> > + if (plca_cfg->node_cnt >= 0 || plca_cfg->node_id >= 0) {
> > + if (plca_cfg->node_cnt < 0 || plca_cfg->node_id < 0) {
>
> I think it would be good to add some comments since this code is not
> immediately obvious to me. I had to think about it for a while.
Yes, I realize it is not very intuitive at furst glance :-)
I have added a comment explaining that we need to read back the register
to perform merge/pure of the configuration IFF we need to set one among
node ID / node count but not both.

>
> > + if (plca_cfg->burst_cnt >= 0 || plca_cfg->burst_tmr >= 0) {
> > + if (plca_cfg->burst_cnt < 0 || plca_cfg->burst_tmr < 0) {
> > + ret = phy_read_mmd(phydev, MDIO_MMD_VEND2,
> > + MDIO_OATC14_PLCA_BURST);
> > +
>
> This follows the same patterns, so maybe comments here as well?
Yup, added the same comment.
>
> With that, you can add my Reviewed-by.
Thanks!
>
> Andrew