Re: [PATCH net-next 0/5] ATU and FDB synchronization on locked ports

[Ido Schimmel <idosch@idosch.org>]

On Thu, Feb 02, 2023 at 05:19:07PM +0100, netdev@kapio-technology.com wrote:
> On 2023-02-02 16:43, Ido Schimmel wrote:
> > On Thu, Feb 02, 2023 at 08:37:08AM +0100, netdev@kapio-technology.com
> > wrote:
> > > On 2023-01-31 20:25, Ido Schimmel wrote:
> > > >
> > > > Will try to review tomorrow, but it looks like this set is missing
> > > > selftests. What about extending bridge_locked_port.sh?
> > > 
> > > I knew you would take this up. :-)
> > > But I am not sure that it's so easy to have selftests here as it is
> > > timing
> > > based and it would take the 5+ minutes just waiting to test in the
> > > stadard
> > > case, and there is opnly support for mv88e6xxx driver with this
> > > patch set.
> > 
> > The ageing time is configurable: See commit 081197591769 ("selftests:
> > net: bridge: Parameterize ageing timeout"). Please add test cases in the
> > next version.
> 
> When I was looking at configuring the ageing time last time, my finding was
> that the ageing time could not be set very low as there was some part in the
> DSA layer etc, and confusion wrt units. I think the minimum secured was like
> around 2 min. (not validated), which is not that much of an improvement for
> fast testing. If you know what would be a good low timeout to set, I would
> like to know.

My point is that the ageing time is parametrized via 'LOW_AGEING_TIME'
in forwarding.config so just use '$LOW_AGEING_TIME' in the selftest and
set it as high as it needs to be for mv88e6xxx in your own
forwarding.config.