Re: [PATCH 1/5] dt-bindings: can: tcan4x5x: Add tcan4552 and tcan4553 variants

[Simon Horman <simon.horman@corigine.com>]

On Tue, Mar 14, 2023 at 04:11:57PM +0100, Markus Schneider-Pargmann wrote:
> These two new chips do not have state or wake pins.
> 
> Signed-off-by: Markus Schneider-Pargmann <msp@baylibre.com>

Not a requirement from my side,
but perhaps it would be worth converting this binding to yaml
at some point.

> ---
>  .../devicetree/bindings/net/can/tcan4x5x.txt          | 11 ++++++++---
>  1 file changed, 8 insertions(+), 3 deletions(-)
> 
> diff --git a/Documentation/devicetree/bindings/net/can/tcan4x5x.txt b/Documentation/devicetree/bindings/net/can/tcan4x5x.txt
> index e3501bfa22e9..38a2b5369b44 100644
> --- a/Documentation/devicetree/bindings/net/can/tcan4x5x.txt
> +++ b/Documentation/devicetree/bindings/net/can/tcan4x5x.txt
> @@ -4,7 +4,10 @@ Texas Instruments TCAN4x5x CAN Controller
>  This file provides device node information for the TCAN4x5x interface contains.
>  
>  Required properties:
> -	- compatible: "ti,tcan4x5x"
> +	- compatible:
> +		"ti,tcan4x5x" or
> +		"ti,tcan4552" or
> +		"ti,tcan4553"
>  	- reg: 0
>  	- #address-cells: 1
>  	- #size-cells: 0
> @@ -21,8 +24,10 @@ Optional properties:
>  	- reset-gpios: Hardwired output GPIO. If not defined then software
>  		       reset.
>  	- device-state-gpios: Input GPIO that indicates if the device is in
> -			      a sleep state or if the device is active.
> -	- device-wake-gpios: Wake up GPIO to wake up the TCAN device.
> +			      a sleep state or if the device is active. Not
> +			      available with tcan4552/4553.
> +	- device-wake-gpios: Wake up GPIO to wake up the TCAN device. Not
> +			     available with tcan4552/4553.
>  
>  Example:
>  tcan4x5x: tcan4x5x@0 {
> -- 
> 2.39.2
>