Re: [PATCH net-next 3/6] net: phy: update in-band AN mode when changing interface by PHY driver

[Simon Horman <simon.horman@corigine.com>]

On Thu, Jun 22, 2023 at 12:19:02PM +0800, Choong Yong Liang wrote:
> From: "Tan, Tee Min" <tee.min.tan@linux.intel.com>
> 
> Add cur_link_an_mode into phy_device struct for PHY drivers to
> communicate the in-band AN mode setting with phylink framework.
> 
> As there is a mechanism in PHY drivers to switch the PHY interface
> between SGMII and 2500BaseX according to link speed. In this case,
> the in-band AN mode should be switching based on the PHY interface
> as well, if the PHY interface has been changed/updated by PHY driver.
> 
> For e.g., disable in-band AN in 2500BaseX mode, or enable in-band AN
> back for SGMII mode (10/100/1000Mbps).
> 
> Signed-off-by: Tan, Tee Min <tee.min.tan@linux.intel.com>
> Signed-off-by: Choong Yong Liang <yong.liang.choong@linux.intel.com>

...

> diff --git a/include/linux/phy.h b/include/linux/phy.h
> index 11c1e91563d4..c685b526e307 100644
> --- a/include/linux/phy.h
> +++ b/include/linux/phy.h
> @@ -756,6 +756,8 @@ struct phy_device {
>  	/* MACsec management functions */
>  	const struct macsec_ops *macsec_ops;
>  #endif
> +	/* For communicate the AN mode setting with phylink framework. */
> +	u8 cur_link_an_mode;
>  };

Hi Choong Yong Liang,

Please consider adding cur_link_an_mode to the kernel doc
for struct phy_device - which is above the definition of struct phy_device.