Re: [PATCH v2] usbnet: asix AX88772: leave the carrier control to phylink

[Oleksij Rempel <o.rempel@pengutronix.de>]

On Tue, Apr 08, 2025 at 01:59:41PM +0200, Krzysztof Hałasa wrote:
> ASIX AX88772B based USB 10/100 Ethernet adapter doesn't come
> up ("carrier off"), despite the built-in 100BASE-FX PHY positive link
> indication. The internal PHY is configured (using EEPROM) in fixed
> 100 Mbps full duplex mode.
> 
> The primary problem appears to be using carrier_netif_{on,off}() while,
> at the same time, delegating carrier management to phylink. Use only the
> latter and remove "manual control" in the asix driver.
> 
> I don't have any other AX88772 board here, but the problem doesn't seem
> specific to a particular board or settings - it's probably
> timing-dependent.
> 
> Remove unused asix_adjust_link() as well.
> 
> Signed-off-by: Krzysztof Hałasa <khalasa@piap.pl>

Tested-by: Oleksij Rempel <o.rempel@pengutronix.de>
 
Link detection is still working on variants with copper interface.

Thank you!

Best Regards,
Oleksij
-- 
Pengutronix e.K.                           |                             |
Steuerwalder Str. 21                       | http://www.pengutronix.de/  |
31137 Hildesheim, Germany                  | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |