Re: [PATCH v3 net-next 1/6] net: phy: realtek: configure SerDes mode for rtl822xb PHYs

["Russell King (Oracle)" <linux@armlinux.org.uk>]

On Tue, Apr 02, 2024 at 07:58:43AM +0200, Eric Woudstra wrote:
> From: Alexander Couzens <lynxis@fe80.eu>
> 
> The rtl8221b and rtl8226b series support switching SerDes mode between
> 2500base-x and sgmii based on the negotiated copper speed.
> 
> Configure this switching mode according to SerDes modes supported by
> host.
> 
> There is an additional datasheet for RTL8226B/RTL8221B called
> "SERDES MODE SETTING FLOW APPLICATION NOTE" where a sequence is
> described to setup interface and rate adapter mode.
> 
> However, there is no documentation about the meaning of registers
> and bits, it's literally just magic numbers and pseudo-code.
> 
> Signed-off-by: Alexander Couzens <lynxis@fe80.eu>
> [ refactored, dropped HiSGMII mode and changed commit message ]
> Signed-off-by: Marek Behún <kabel@kernel.org>
> [ changed rtl822x_update_interface() to use vendor register ]
> [ always fill in possible interfaces ]
> [ only apply to rtl8221b and rtl8226b phy's ]
> [ set phydev->rate_matching in .config_init() ]
> Signed-off-by: Eric Woudstra <ericwouds@gmail.com>

Reviewed-by: Russell King (Oracle) <rmk+kernel@armlinux.org.uk>

Thanks!

-- 
RMK's Patch system: https://www.armlinux.org.uk/developer/patches/
FTTP is here! 80Mbps down 10Mbps up. Decent connectivity at last!