Re: [PATCH net-next v2 3/3] ipv4: Centralize TOS matching

[Guillaume Nault <gnault@redhat.com>]

On Wed, Aug 14, 2024 at 03:52:24PM +0300, Ido Schimmel wrote:
> The TOS field in the IPv4 flow information structure ('flowi4_tos') is
> matched by the kernel against the TOS selector in IPv4 rules and routes.
> The field is initialized differently by different call sites. Some treat
> it as DSCP (RFC 2474) and initialize all six DSCP bits, some treat it as
> RFC 1349 TOS and initialize it using RT_TOS() and some treat it as RFC
> 791 TOS and initialize it using IPTOS_RT_MASK.
> 
> What is common to all these call sites is that they all initialize the
> lower three DSCP bits, which fits the TOS definition in the initial IPv4
> specification (RFC 791).
> 
> Therefore, the kernel only allows configuring IPv4 FIB rules that match
> on the lower three DSCP bits which are always guaranteed to be
> initialized by all call sites:
> 
>  # ip -4 rule add tos 0x1c table 100
>  # ip -4 rule add tos 0x3c table 100
>  Error: Invalid tos.
> 
> While this works, it is unlikely to be very useful. RFC 791 that
> initially defined the TOS and IP precedence fields was updated by RFC
> 2474 over twenty five years ago where these fields were replaced by a
> single six bits DSCP field.
> 
> Extending FIB rules to match on DSCP can be done by adding a new DSCP
> selector while maintaining the existing semantics of the TOS selector
> for applications that rely on that.
> 
> A prerequisite for allowing FIB rules to match on DSCP is to adjust all
> the call sites to initialize the high order DSCP bits and remove their
> masking along the path to the core where the field is matched on.
> 
> However, making this change alone will result in a behavior change. For
> example, a forwarded IPv4 packet with a DS field of 0xfc will no longer
> match a FIB rule that was configured with 'tos 0x1c'.
> 
> This behavior change can be avoided by masking the upper three DSCP bits
> in 'flowi4_tos' before comparing it against the TOS selectors in FIB
> rules and routes.
> 
> Implement the above by adding a new function that checks whether a given
> DSCP value matches the one specified in the IPv4 flow information
> structure and invoke it from the three places that currently match on
> 'flowi4_tos'.

A bit late for the review, but anyway...

Reviewed-by: Guillaume Nault <gnault@redhat.com>

Thanks Ido!