On Oct 15, Alex Elder wrote:
> From: Daniel Thompson <daniel@riscstar.com>
> 
> QCA8081 appears in embedded board designs paired with GPIO controlled
> regulators for its power rails. Add logic to allow these regulators to
> be turned on during a probe.
> 
> In order to avoid the complexity of tracking state for suspend with and
> without WoL we take a tremendously simple "always-on" approach to
> regulator management, essentially relying on BMCR_PDOWN to conserve
> power when the phy device exists.
> 
> Signed-off-by: Daniel Thompson <daniel@riscstar.com>
> Co-developed-by: Alex Elder <elder@riscstar.com>
> Signed-off-by: Alex Elder <elder@riscstar.com>
> ---
>  drivers/net/phy/qcom/qca808x.c | 29 +++++++++++++++++++++++++++++
>  1 file changed, 29 insertions(+)
> 
> diff --git a/drivers/net/phy/qcom/qca808x.c b/drivers/net/phy/qcom/qca808x.c
> index bab26e4c61408..4aba513b9a512 100644
> --- a/drivers/net/phy/qcom/qca808x.c
> +++ b/drivers/net/phy/qcom/qca808x.c
> @@ -1,6 +1,7 @@
>  // SPDX-License-Identifier: GPL-2.0+
>  
>  #include <linux/phy.h>
> +#include <linux/regulator/consumer.h>
>  #include <linux/module.h>
>  
>  #include "qcom.h"
> @@ -181,15 +182,43 @@ static void qca808x_fill_possible_interfaces(struct phy_device *phydev)
>  		__set_bit(PHY_INTERFACE_MODE_2500BASEX, possible);
>  }
>  
> +static int qca808x_power_on(struct phy_device *phydev)
> +{
> +	static const char * const regulator_names[] = {
> +		"avdd18", "vdd", "vdd18", "vdd125"
> +	};
> +	struct device *dev = &phydev->mdio.dev;
> +	u32 count = 0;
> +	int ret;
> +
> +	for (u32 i = 0; i < ARRAY_SIZE(regulator_names); i++) {
> +		ret = devm_regulator_get_enable_optional(dev, regulator_names[i]);
> +		if (!ret)
> +			count++;
> +		else if (ret != -ENODEV)
> +			return ret;
> +	}
> +
> +	if (count)
> +		fsleep(phydev->mdio.reset_assert_delay);

nit: should we check reset_assert_delay field is actually set?

Regards,
Lorenzo

> +
> +	return 0;
> +}
> +
>  static int qca808x_probe(struct phy_device *phydev)
>  {
>  	struct device *dev = &phydev->mdio.dev;
>  	struct qca808x_priv *priv;
> +	int ret;
>  
>  	priv = devm_kzalloc(dev, sizeof(*priv), GFP_KERNEL);
>  	if (!priv)
>  		return -ENOMEM;
>  
> +	ret = qca808x_power_on(phydev);
> +	if (ret)
> +		return ret;
> +
>  	priv->led_polarity_mode = QCA808X_PHY_LED_UNSET;
>  
>  	phydev->priv = priv;
> -- 
> 2.53.0
>