Re: [PATCH] net: stmmac: dwmac-loongson: Add fix_soc_reset function

[Yanteng Si <si.yanteng@linux.dev>]

在 2025/1/22 09:31, Qunqin Zhao 写道:
>
> 在 2025/1/21 下午9:41, Yanteng Si 写道:
>>
>> 在 1/21/25 16:25, Qunqin Zhao 写道:
>>> Loongson's GMAC device takes nearly two seconds to complete DMA reset,
>>> however, the default waiting time for reset is 200 milliseconds
>> Is only GMAC like this?
> At present, this situation has only been found on GMAC.

>>> @@ -566,6 +578,7 @@ static int loongson_dwmac_probe(struct pci_dev 
>>> *pdev, const struct pci_device_id
>>>         plat->bsp_priv = ld;
>>>       plat->setup = loongson_dwmac_setup;
>>> +    plat->fix_soc_reset = loongson_fix_soc_reset;
>>
>> If only GMAC needs to be done this way, how about putting it inside 
>> the loongson_gmac_data()?
>
> Regardless of whether this situation occurs in other devices(like 
> gnet), this change will not have any impact on gnet, right?
>
Yeah，However, it is obvious that there is now a more suitable
place for it. In the Loongson driver, `loongson_gmac_data()`
and `loongson_default_data()` were designed from the beginning.
When GNET support was added later, `loongson_gnet_data()`
was designed. We once made great efforts to extract these codes
from the `probe()` . Are we going to go back to the past?

Of course, I'm not saying that I disagree with you fixing the
GMAC in the `probe()`. I just think it's a bad start. After that,
other people may also put similar code here, and eventually
it will make the `probe` a mess.

If you insist on doing this, please change the function name
to `loongson_gmac_fix_reset()`, just like `loongson_gnet_fix_speed`.


Thanks,
Yanteng