Re: IMQ / new Dummy device post.

[syrius.ml@no-log.org]

jamal <hadi@cyberus.ca> writes:

[...]
>> $TC qdisc add dev ppp0 root handle 1: prio
>> $TC filter add dev ppp0 parent 1:0 protocol ip prio 10 u32 \
>>     match u32 0 0 flowid 1:1 action mirred egress redirect dev dummy0
> Note: this will do for ipv4; if you want ipv6 add a new rule,
> in addition to above if you want ipv4, with "protocol ip" replaced by
> "protocol ipv6"

>> $TC qdisc add dev tun0 root handle 1: prio
>> $TC filter add dev tun0 parent 1:0 protocol ip prio 10 u32 \
>>     match u32 0 0 flowid 1:1 action mirred egress redirect dev dummy0
>> $TC qdisc add dev sit1 root handle 1: prio
>> $TC filter add dev sit1 parent 1:0 protocol ipv6 prio 10 u32 \
>>     match u32 0 0 flowid 1:1 action mirred egress redirect dev dummy0
> not sure if you need the above but i dont know your setup sufficiently
> to be 100%

using 'protocol ipv6' on ppp0 rather than sit1 did the trick.
It's even simplier ! I don't have to create filters for each ipv6 tunnel.

Considering the ipv4 over udp tun0 tunnel, i guess i should prevent
those udp packets to be matched by the filter on ppp0.
I'll optimize it later.

Cheers
                                                        
--