Re: [PATCH] Update TERMCMD message to align with previous change

[Gary Thomas <gary@mlbassoc.com>]

On 2011-07-27 09:03, Joshua Lock wrote:
> On Tue, 2011-07-26 at 14:22 -0500, Matthew McClintock wrote:
>> A previous patch changed the default TERM to use xterm. This updates
>> local.conf.sample to match the change
>>
>> Signed-off-by: Matthew McClintock<msm@freescale.com>
>
> Signed-off-by: Joshua Lock<josh@linux.intel.com>
>
> We should probably change the suggested / commented TERMCMD to be
> something other than KONSOLE too, as that doesn't work so well for
> KDE4...

or remotely via SSH tunnel

xterm does work fine via SSH, so I've changed to that.

>> ---
>>   meta-yocto/conf/local.conf.sample |    2 +-
>>   1 files changed, 1 insertions(+), 1 deletions(-)
>>
>> diff --git a/meta-yocto/conf/local.conf.sample b/meta-yocto/conf/local.conf.sample
>> index 499c48e..7a0fc89 100644
>> --- a/meta-yocto/conf/local.conf.sample
>> +++ b/meta-yocto/conf/local.conf.sample
>> @@ -205,7 +205,7 @@ ENABLE_BINARY_LOCALE_GENERATION = "1"
>>   # out if that is desired
>>   NO32LIBS = "1"
>>
>> -# If you do not use (or have installed) gnome-terminal you will need to
>> +# If you do not use (or have installed) xterm you will need to
>>   # uncomment these variables and set them to the terminal you wish to use
>>   # when resolving patches which cannot be applied
>>   # Supported shell prefixes for *_TERMCMD and *_TERMCMDRUN ARE:
>

-- 
------------------------------------------------------------
Gary Thomas                 |  Consulting for the
MLB Associates              |    Embedded world
------------------------------------------------------------