Re: QEMU with ARM Cortex A9 with hard float configuration - Kernel panic

[Bruce Ashfield <bruce.ashfield@windriver.com>]

On 13-08-29 10:02 AM, Elvis Dowson wrote:
> Hi Bruce,
>
> On Aug 29, 2013, at 4:35 PM, Bruce Ashfield <bruce.ashfield@windriver.com> wrote:
>
>> With that, it's always been a manual setup for me in the past. The typical
>> workflow is to test them via the usermode NFS boot. Have you given
>> that a go ?
>
> Does yocto have some wrapper script/command to setup nfs boot automatically
> without too much manual configuration? The runqemu and runqemu-internal
> scripts seems to indicate that, but haven't tried this before.
>
> Let me know if it exists! If not, if you could point me to a link that describes how
> to set NFS boot, and use it to load a beagleboard image it would be great!

This is supported right out of the box, and it should be documented in
the project docs.

Search for users-space NFS in 
http://www.yoctoproject.org/docs/current/adt-manual/adt-manual.html

Cheers,

Bruce

>
>> Once I'm over the 3.10 introduction curve, I'm happy to dust off my
>> old A9 support and get the right qemu support for a full system boot.
>
> That sounds good. We should aim for adding support for both A8 and A9,
> since that represent the current bulk of last-gen and current-gen platforms
> out there.
>
> Best regards,
>
> Elvis Dowson
>
>