Re: [PATCH] serial-getty@.service: Allow device to fast fail if it does not exist

[richard.purdie@linuxfoundation.org]

On Wed, 2019-08-28 at 15:24 -0500, Jason Wessel wrote:
> On 8/27/19 7:15 PM, richard.purdie@linuxfoundation.org wrote:
> > On Tue, 2019-08-27 at 19:03 -0500, Jason Wessel wrote:
> > > On 8/27/19 5:58 PM, Richard Purdie wrote:
> > > > Hi Jason,
> > > > Somehow this change is responsible for this build failure:
> > > > 
> > > > https://autobuilder.yoctoproject.org/typhoon/#/builders/72/builds/976
> > > > 
> > > > (steps 5c and 7c so failure during testimage).
> > > > 
> > > > I have bisected it to this change, I haven't looked into why.
> > > 
> > > Thanks for tracking it down.   I am sure how to try an duplicate
> > > this.  I clicked around to try and find out a bit about what it
> > > is
> > > running for these phases of the build but it is not very obvious.
> > > 
> > > Is there a local.conf I can try along with what ever commands it
> > > ran?
> > 
> > The configuration its using is shown in
> > https://autobuilder.yoctoproject.org/typhoon/#/builders/72/builds/978/steps/8/logs/stdio
> > for each step.
> > 
> 
> I tried the configuration on my system but it seems to work fine, see
> below.   Is there a way to get complete log file of the boot on the
> broken host?  I am also curious if it fails every time or not.
> 
> /home/pokybuild/yocto-worker/qa-
> extras2/build/build/tmp/work/qemux86_64-poky-linux/core-image-
> sato/1.0-r0/testimage/qemu_boot_log.20190827200002

If we'd got this straight after the build then yes but its been
recycled now.

It did seem to fail repeatedly when I tested it. I'd probably have to
add the patch back and retest again to get the log.

> I am not sure it will tell us anything further or not, but it
> certainly looks like the system didn't boot correctly in the first
> place.

It does seem like a boot issue somehow...

The test case one the autobuilder seems simple enough, systemd boot
alone with no sysvinit.

Cheers,

Richard