From: Richard Henderson <rth@twiddle.net>
To: qemu-devel@nongnu.org
Subject: [Qemu-devel] [PATCH 14/33] target-alpha: Use do_restore_state for arithmetic exceptions.
Date: Thu, 28 Apr 2011 13:50:56 -0700 [thread overview]
Message-ID: <1304023875-25040-15-git-send-email-rth@twiddle.net> (raw)
In-Reply-To: <1304023875-25040-1-git-send-email-rth@twiddle.net>
This gets the PC right after an arithmetic exception. Also tidies
the code in the TLB fault handlers to use common code.
Signed-off-by: Richard Henderson <rth@twiddle.net>
---
target-alpha/op_helper.c | 49 ++++++++++++++++++++++++++++-----------------
1 files changed, 30 insertions(+), 19 deletions(-)
diff --git a/target-alpha/op_helper.c b/target-alpha/op_helper.c
index 672940e..fc5020a 100644
--- a/target-alpha/op_helper.c
+++ b/target-alpha/op_helper.c
@@ -25,20 +25,42 @@
/*****************************************************************************/
/* Exceptions processing helpers */
-void QEMU_NORETURN helper_excp (int excp, int error)
+
+/* This should only be called from translate, via gen_excp.
+ We expect that ENV->PC has already been updated. */
+void QEMU_NORETURN helper_excp(int excp, int error)
+{
+ env->exception_index = excp;
+ env->error_code = error;
+ cpu_loop_exit();
+}
+
+static void do_restore_state(void *retaddr)
+{
+ unsigned long pc = (unsigned long)retaddr;
+
+ if (pc) {
+ TranslationBlock *tb = tb_find_pc(pc);
+ if (tb) {
+ cpu_restore_state(tb, env, pc);
+ }
+ }
+}
+
+/* This may be called from any of the helpers to set up EXCEPTION_INDEX. */
+static void QEMU_NORETURN dynamic_excp(int excp, int error)
{
env->exception_index = excp;
env->error_code = error;
+ do_restore_state(GETPC());
cpu_loop_exit();
}
static void QEMU_NORETURN arith_excp(int exc, uint64_t mask)
{
- env->exception_index = EXCP_ARITH;
- env->error_code = 0;
env->trap_arg0 = exc;
env->trap_arg1 = mask;
- cpu_loop_exit();
+ dynamic_excp(EXCP_ARITH, 0);
}
uint64_t helper_load_pcc (void)
@@ -521,7 +543,7 @@ static inline float32 f_to_float32(uint64_t a)
if (unlikely(!exp && mant_sig)) {
/* Reserved operands / Dirty zero */
- helper_excp(EXCP_OPCDEC, 0);
+ dynamic_excp(EXCP_OPCDEC, 0);
}
if (exp < 3) {
@@ -651,7 +673,7 @@ static inline float64 g_to_float64(uint64_t a)
if (!exp && mant_sig) {
/* Reserved operands / Dirty zero */
- helper_excp(EXCP_OPCDEC, 0);
+ dynamic_excp(EXCP_OPCDEC, 0);
}
if (exp < 3) {
@@ -1260,9 +1282,7 @@ uint64_t helper_stq_c_phys(uint64_t p, uint64_t v)
/* XXX: fix it to restore all registers */
void tlb_fill (target_ulong addr, int is_write, int mmu_idx, void *retaddr)
{
- TranslationBlock *tb;
CPUState *saved_env;
- unsigned long pc;
int ret;
/* XXX: hack to restore env in all cases, even if not called from
@@ -1270,17 +1290,8 @@ void tlb_fill (target_ulong addr, int is_write, int mmu_idx, void *retaddr)
saved_env = env;
env = cpu_single_env;
ret = cpu_alpha_handle_mmu_fault(env, addr, is_write, mmu_idx, 1);
- if (!likely(ret == 0)) {
- if (likely(retaddr)) {
- /* now we have a real cpu fault */
- pc = (unsigned long)retaddr;
- tb = tb_find_pc(pc);
- if (likely(tb)) {
- /* the PC is inside the translated code. It means that we have
- a virtual CPU fault */
- cpu_restore_state(tb, env, pc);
- }
- }
+ if (unlikely(ret != 0)) {
+ do_restore_state(retaddr);
/* Exception index and error code are already set */
cpu_loop_exit();
}
--
1.7.4.4
next prev parent reply other threads:[~2011-04-28 20:51 UTC|newest]
Thread overview: 40+ messages / expand[flat|nested] mbox.gz Atom feed top
2011-04-28 20:50 [Qemu-devel] [PATCH 00/33] Alpha system emulation, v3 Richard Henderson
2011-04-28 20:50 ` [Qemu-devel] [PATCH 01/33] Export the unassigned_mem read/write functions Richard Henderson
2011-04-28 20:50 ` [Qemu-devel] [PATCH 02/33] gdbserver: Don't deliver TIMER interrupts when SSTEP_NOIRQ either Richard Henderson
2011-04-29 20:53 ` Blue Swirl
2011-04-29 22:39 ` Richard Henderson
2011-04-30 6:35 ` Blue Swirl
2011-04-28 20:50 ` [Qemu-devel] [PATCH 03/33] target-alpha: Disassemble EV6 PALcode instructions Richard Henderson
2011-04-28 20:50 ` [Qemu-devel] [PATCH 04/33] pci: Export pci_to_cpu_addr Richard Henderson
2011-04-28 20:50 ` [Qemu-devel] [PATCH 05/33] target-alpha: Single-step properly across branches Richard Henderson
2011-04-28 20:50 ` [Qemu-devel] [PATCH 06/33] target-alpha: Remove partial support for palcode emulation Richard Henderson
2011-04-28 20:50 ` [Qemu-devel] [PATCH 07/33] target-alpha: Enable the alpha-softmmu target Richard Henderson
2011-04-28 20:50 ` [Qemu-devel] [PATCH 08/33] target-alpha: Tidy exception constants Richard Henderson
2011-04-28 20:50 ` [Qemu-devel] [PATCH 09/33] target-alpha: Rationalize internal processor registers Richard Henderson
2011-04-28 20:50 ` [Qemu-devel] [PATCH 10/33] target-alpha: Cleanup MMU modes Richard Henderson
2011-04-28 20:50 ` [Qemu-devel] [PATCH 11/33] target-alpha: Fixup translation of PALmode instructions Richard Henderson
2011-04-28 20:50 ` [Qemu-devel] [PATCH 12/33] target-alpha: Add IPRs to be used by the emulation PALcode Richard Henderson
2011-04-28 20:50 ` [Qemu-devel] [PATCH 13/33] target-alpha: Tidy up arithmetic exceptions Richard Henderson
2011-04-28 20:50 ` Richard Henderson [this message]
2011-04-28 20:50 ` [Qemu-devel] [PATCH 15/33] target-alpha: Merge HW_REI and HW_RET implementations Richard Henderson
2011-04-28 20:50 ` [Qemu-devel] [PATCH 16/33] target-alpha: Implement do_interrupt for system mode Richard Henderson
2011-04-28 20:50 ` [Qemu-devel] [PATCH 17/33] target-alpha: Swap shadow registers moving to/from PALmode Richard Henderson
2011-04-28 20:51 ` [Qemu-devel] [PATCH 18/33] target-alpha: Add various symbolic constants Richard Henderson
2011-04-28 20:51 ` [Qemu-devel] [PATCH 19/33] target-alpha: Use kernel mmu_idx for pal_mode Richard Henderson
2011-04-28 20:51 ` [Qemu-devel] [PATCH 20/33] target-alpha: All ISA checks to use TB->FLAGS Richard Henderson
2011-04-28 20:51 ` [Qemu-devel] [PATCH 21/33] target-alpha: Disable interrupts properly Richard Henderson
2011-04-28 20:51 ` [Qemu-devel] [PATCH 22/33] target-alpha: Implement more CALL_PAL values inline Richard Henderson
2011-04-28 20:51 ` [Qemu-devel] [PATCH 23/33] target-alpha: Implement cpu_alpha_handle_mmu_fault for system mode Richard Henderson
2011-04-28 20:51 ` [Qemu-devel] [PATCH 24/33] target-alpha: Remap PIO space for 43-bit KSEG for EV6 Richard Henderson
2011-04-28 20:51 ` [Qemu-devel] [PATCH 25/33] target-alpha: Trap for unassigned and unaligned addresses Richard Henderson
2011-04-28 20:51 ` [Qemu-devel] [PATCH 26/33] target-alpha: Include the PCC_OFS in the RPCC return value Richard Henderson
2011-04-28 20:51 ` [Qemu-devel] [PATCH 27/33] target-alpha: Use a fixed frequency for the RPCC in system mode Richard Henderson
2011-04-28 20:51 ` [Qemu-devel] [PATCH 28/33] target-alpha: Implement TLB flush primitives Richard Henderson
2011-04-28 20:51 ` [Qemu-devel] [PATCH 29/33] target-alpha: Add custom PALcode image for CLIPPER emulation Richard Henderson
2011-04-29 9:13 ` Peter Maydell
2011-04-29 13:13 ` Richard Henderson
2011-04-28 20:51 ` [Qemu-devel] [PATCH 30/33] target-alpha: Add " Richard Henderson
2011-04-28 20:51 ` [Qemu-devel] [PATCH 31/33] target-alpha: Implement WAIT IPR Richard Henderson
2011-04-28 20:51 ` [Qemu-devel] [PATCH 32/33] target-alpha: Implement HALT IPR Richard Henderson
2011-04-28 20:51 ` [Qemu-devel] [PATCH 33/33] target-alpha: Add high-resolution access to wall clock and an alarm Richard Henderson
2011-04-29 8:36 ` [Qemu-devel] [PATCH 00/33] Alpha system emulation, v3 Paolo Bonzini
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1304023875-25040-15-git-send-email-rth@twiddle.net \
--to=rth@twiddle.net \
--cc=qemu-devel@nongnu.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).