[Qemu-devel] [PATCH 2/4] qcow2: mark image clean after repair succeeds

[Stefan Hajnoczi <stefanha@linux.vnet.ibm.com>]

The dirty bit is cleared after image repair succeeds in qcow2_open().
Move this into qcow2_check() so that all callers benefit from this
behavior when fix mode is enabled.

This is necessary so qemu-img check can call .bdrv_check() and mark the
image clean.

Signed-off-by: Stefan Hajnoczi <stefanha@linux.vnet.ibm.com>
---
 block/qcow2.c |   28 +++++++++++++++-------------
 1 file changed, 15 insertions(+), 13 deletions(-)

diff --git a/block/qcow2.c b/block/qcow2.c
index fd5e214..887e198 100644
--- a/block/qcow2.c
+++ b/block/qcow2.c
@@ -270,6 +270,20 @@ static int qcow2_mark_clean(BlockDriverState *bs)
     return 0;
 }
 
+static int qcow2_check(BlockDriverState *bs, BdrvCheckResult *result,
+                       BdrvCheckMode fix)
+{
+    int ret = qcow2_check_refcounts(bs, result, fix);
+    if (ret < 0) {
+        return ret;
+    }
+
+    if (fix && result->check_errors == 0) {
+        return qcow2_mark_clean(bs);
+    }
+    return ret;
+}
+
 static int qcow2_open(BlockDriverState *bs, int flags)
 {
     BDRVQcowState *s = bs->opaque;
@@ -474,12 +488,7 @@ static int qcow2_open(BlockDriverState *bs, int flags)
         !bs->read_only) {
         BdrvCheckResult result = {0};
 
-        ret = qcow2_check_refcounts(bs, &result, BDRV_FIX_ERRORS);
-        if (ret < 0) {
-            goto fail;
-        }
-
-        ret = qcow2_mark_clean(bs);
+        ret = qcow2_check(bs, &result, BDRV_FIX_ERRORS);
         if (ret < 0) {
             goto fail;
         }
@@ -1568,13 +1577,6 @@ static int qcow2_get_info(BlockDriverState *bs, BlockDriverInfo *bdi)
     return 0;
 }
 
-
-static int qcow2_check(BlockDriverState *bs, BdrvCheckResult *result,
-                       BdrvCheckMode fix)
-{
-    return qcow2_check_refcounts(bs, result, fix);
-}
-
 #if 0
 static void dump_refcounts(BlockDriverState *bs)
 {
-- 
1.7.10.4