Re: [PATCH 6/6] mtest2make: stop disabling meson test timeouts

[Thomas Huth <thuth@redhat.com>]

On 01/06/2023 18.31, Daniel P. Berrangé wrote:
> The mtest2make.py script passes the arg '-t 0' to 'meson test' which
> disables all test timeouts. This is a major source of pain when running
> in GitLab CI and a test gets stuck. It will stall until GitLab kills the
> CI job. This leaves us with little easily consumable information about
> the stalled test. The TAP format doesn't show the test name until it is
> completed, and TAP output from multiple tests it interleaved. So we
> have to analyse the log to figure out what tests had un-finished TAP
> output present and thus infer which test case caused the hang. This is
> very time consuming and error prone.
> 
> By allowing meson to kill stalled tests, we get a direct display of what
> test program got stuck, which lets us more directly focus in on what
> specific test case within the test program hung.
> 
> The other issue with disabling meson test timeouts by default is that it
> makes it more likely that maintainers inadvertantly introduce slowdowns.
> For example the recent-ish change that accidentally made migrate-test
> take 15-20 minutes instead of around 1 minute.
> 
> The main risk of this change is that the individual test timeouts might
> be too short to allow completion in high load scenarios. Thus, there is
> likely to be some short term pain where we have to bump the timeouts for
> certain tests to make them reliable enough. The preceeding few patches
> raised the timeouts for all failures that were immediately apparent
> in GitLab CI.
> 
> Even with the possible short term instability, this should still be a
> net win for debuggability of failed CI pipelines over the long term.
> 
> Signed-off-by: Daniel P. Berrangé <berrange@redhat.com>
> ---
>   scripts/mtest2make.py | 3 ++-
>   1 file changed, 2 insertions(+), 1 deletion(-)
> 
> diff --git a/scripts/mtest2make.py b/scripts/mtest2make.py
> index 179dd54871..eb01a05ddb 100644
> --- a/scripts/mtest2make.py
> +++ b/scripts/mtest2make.py
> @@ -27,7 +27,8 @@ def names(self, base):
>   .speed.slow = $(foreach s,$(sort $(filter-out %-thorough, $1)), --suite $s)
>   .speed.thorough = $(foreach s,$(sort $1), --suite $s)
>   
> -.mtestargs = --no-rebuild -t 0
> +TIMEOUT_MULTIPLIER = 1
> +.mtestargs = --no-rebuild -t $(TIMEOUT_MULTIPLIER)
>   ifneq ($(SPEED), quick)
>   .mtestargs += --setup $(SPEED)
>   endif

Basically Ack, but could you please double-check that "make check 
-j$(nproc)" still works if configure has been run with "--enable-debug" ? 
... maybe we need to adjust the multiplier in that case...

  Thomas