From: Leon Alrae <leon.alrae@imgtec.com>
To: qemu-devel@nongnu.org
Cc: "Maciej W. Rozycki" <macro@codesourcery.com>
Subject: [Qemu-devel] [PULL 21/30] target-mips: gdbstub: Clean up FPU register handling
Date: Tue, 16 Dec 2014 19:49:07 +0000 [thread overview]
Message-ID: <1418759356-14242-22-git-send-email-leon.alrae@imgtec.com> (raw)
In-Reply-To: <1418759356-14242-1-git-send-email-leon.alrae@imgtec.com>
From: "Maciej W. Rozycki" <macro@codesourcery.com>
Rewrite the FPU register access parts of `mips_cpu_gdb_read_register'
and `mips_cpu_gdb_write_register' for consistency between each other.
Signed-off-by: Maciej W. Rozycki <macro@codesourcery.com>
Reviewed-by: Leon Alrae <leon.alrae@imgtec.com>
Signed-off-by: Leon Alrae <leon.alrae@imgtec.com>
---
target-mips/gdbstub.c | 38 +++++++++++++++++++-------------------
1 file changed, 19 insertions(+), 19 deletions(-)
diff --git a/target-mips/gdbstub.c b/target-mips/gdbstub.c
index 964e6a7..2f2ffd2 100644
--- a/target-mips/gdbstub.c
+++ b/target-mips/gdbstub.c
@@ -29,8 +29,13 @@ int mips_cpu_gdb_read_register(CPUState *cs, uint8_t *mem_buf, int n)
if (n < 32) {
return gdb_get_regl(mem_buf, env->active_tc.gpr[n]);
}
- if (env->CP0_Config1 & (1 << CP0C1_FP)) {
- if (n >= 38 && n < 70) {
+ if (env->CP0_Config1 & (1 << CP0C1_FP) && n >= 38 && n < 72) {
+ switch (n) {
+ case 70:
+ return gdb_get_regl(mem_buf, (int32_t)env->active_fpu.fcr31);
+ case 71:
+ return gdb_get_regl(mem_buf, (int32_t)env->active_fpu.fcr0);
+ default:
if (env->CP0_Status & (1 << CP0St_FR)) {
return gdb_get_regl(mem_buf,
env->active_fpu.fpr[n - 38].d);
@@ -39,12 +44,6 @@ int mips_cpu_gdb_read_register(CPUState *cs, uint8_t *mem_buf, int n)
env->active_fpu.fpr[n - 38].w[FP_ENDIAN_IDX]);
}
}
- switch (n) {
- case 70:
- return gdb_get_regl(mem_buf, (int32_t)env->active_fpu.fcr31);
- case 71:
- return gdb_get_regl(mem_buf, (int32_t)env->active_fpu.fcr0);
- }
}
switch (n) {
case 32:
@@ -64,8 +63,10 @@ int mips_cpu_gdb_read_register(CPUState *cs, uint8_t *mem_buf, int n)
return gdb_get_regl(mem_buf, 0); /* fp */
case 89:
return gdb_get_regl(mem_buf, (int32_t)env->CP0_PRid);
- }
- if (n >= 73 && n <= 88) {
+ default:
+ if (n > 89) {
+ return 0;
+ }
/* 16 embedded regs. */
return gdb_get_regl(mem_buf, 0);
}
@@ -89,15 +90,7 @@ int mips_cpu_gdb_write_register(CPUState *cs, uint8_t *mem_buf, int n)
env->active_tc.gpr[n] = tmp;
return sizeof(target_ulong);
}
- if (env->CP0_Config1 & (1 << CP0C1_FP)
- && n >= 38 && n < 72) {
- if (n < 70) {
- if (env->CP0_Status & (1 << CP0St_FR)) {
- env->active_fpu.fpr[n - 38].d = tmp;
- } else {
- env->active_fpu.fpr[n - 38].w[FP_ENDIAN_IDX] = tmp;
- }
- }
+ if (env->CP0_Config1 & (1 << CP0C1_FP) && n >= 38 && n < 72) {
switch (n) {
case 70:
env->active_fpu.fcr31 = tmp & 0xFF83FFFF;
@@ -107,6 +100,13 @@ int mips_cpu_gdb_write_register(CPUState *cs, uint8_t *mem_buf, int n)
case 71:
/* FIR is read-only. Ignore writes. */
break;
+ default:
+ if (env->CP0_Status & (1 << CP0St_FR)) {
+ env->active_fpu.fpr[n - 38].d = tmp;
+ } else {
+ env->active_fpu.fpr[n - 38].w[FP_ENDIAN_IDX] = tmp;
+ }
+ break;
}
return sizeof(target_ulong);
}
--
2.1.0
next prev parent reply other threads:[~2014-12-16 19:50 UTC|newest]
Thread overview: 32+ messages / expand[flat|nested] mbox.gz Atom feed top
2014-12-16 19:48 [Qemu-devel] [PULL 00/30] target-mips queue Leon Alrae
2014-12-16 19:48 ` [Qemu-devel] [PULL 01/30] target-mips: Correct the handling of register #72 on writes Leon Alrae
2014-12-16 19:48 ` [Qemu-devel] [PULL 02/30] target-mips: Make CP1.FIR read-only here too Leon Alrae
2014-12-16 19:48 ` [Qemu-devel] [PULL 03/30] target-mips: Add 5KEc and 5KEf MIPS64r2 processors Leon Alrae
2014-12-16 19:48 ` [Qemu-devel] [PULL 04/30] target-mips: Make CP0.Config4 and CP0.Config5 registers signed Leon Alrae
2014-12-16 19:48 ` [Qemu-devel] [PULL 05/30] target-mips: Add M14K and M14Kc MIPS32r2 microMIPS processors Leon Alrae
2014-12-16 19:48 ` [Qemu-devel] [PULL 06/30] target-mips: Enable vectored interrupt support for the 74Kf CPU Leon Alrae
2014-12-16 19:48 ` [Qemu-devel] [PULL 07/30] target-mips: Fix formatting in `decode_extended_mips16_opc' Leon Alrae
2014-12-16 19:48 ` [Qemu-devel] [PULL 08/30] target-mips: Fix formatting in `mips_defs' Leon Alrae
2014-12-16 19:48 ` [Qemu-devel] [PULL 09/30] target-mips: Fix formatting in `decode_opc' Leon Alrae
2014-12-16 19:48 ` [Qemu-devel] [PULL 10/30] target-mips: Make `helper_float_cvtw_s' consistent with the remaining helpers Leon Alrae
2014-12-16 19:48 ` [Qemu-devel] [PULL 11/30] target-mips: Remove unused `FLOAT_OP' macro Leon Alrae
2014-12-16 19:48 ` [Qemu-devel] [PULL 12/30] target-mips: Restore the order of helpers Leon Alrae
2014-12-16 19:48 ` [Qemu-devel] [PULL 13/30] target-mips: Correct MIPS16/microMIPS branch size calculation Leon Alrae
2014-12-16 19:49 ` [Qemu-devel] [PULL 14/30] target-mips: Correct the handling of writes to CP0.Status for MIPSr6 Leon Alrae
2014-12-16 19:49 ` [Qemu-devel] [PULL 15/30] target-mips: Correct the writes to Status and Cause registers via gdbstub Leon Alrae
2014-12-16 19:49 ` [Qemu-devel] [PULL 16/30] target-mips: Fix the 64-bit case for microMIPS MOVE16 and MOVEP Leon Alrae
2014-12-16 19:49 ` [Qemu-devel] [PULL 17/30] target-mips: Output CP0.Config2-5 in the register dump Leon Alrae
2014-12-16 19:49 ` [Qemu-devel] [PULL 18/30] target-mips: Fix CP0.Config3.ISAOnExc write accesses Leon Alrae
2014-12-16 19:49 ` [Qemu-devel] [PULL 19/30] target-mips: Tighten ISA level checks Leon Alrae
2014-12-16 19:49 ` [Qemu-devel] [PULL 20/30] target-mips: Correct 32-bit address space wrapping Leon Alrae
2014-12-16 19:49 ` Leon Alrae [this message]
2014-12-16 19:49 ` [Qemu-devel] [PULL 22/30] target-mips: Also apply the CP0.Status mask to MTTC0 Leon Alrae
2014-12-16 19:49 ` [Qemu-devel] [PULL 23/30] linux-user: Use the 5KEf processor for 64-bit emulation Leon Alrae
2014-12-16 19:49 ` [Qemu-devel] [PULL 24/30] target-mips: Add missing calls to synchronise SoftFloat status Leon Alrae
2014-12-16 19:49 ` [Qemu-devel] [PULL 25/30] target-mips: Use local float status pointer across MSA macros Leon Alrae
2014-12-16 19:49 ` [Qemu-devel] [PULL 26/30] target-mips: Fix DisasContext's ulri member initialization Leon Alrae
2014-12-16 19:49 ` [Qemu-devel] [PULL 27/30] target-mips: convert single case switch into if statement Leon Alrae
2014-12-16 19:49 ` [Qemu-devel] [PULL 28/30] disas/mips: remove unused mips_msa_control_names_numeric[32] Leon Alrae
2014-12-16 19:49 ` [Qemu-devel] [PULL 29/30] disas/mips: disable unused mips16_to_32_reg_map[] Leon Alrae
2014-12-16 19:49 ` [Qemu-devel] [PULL 30/30] target-mips: remove excp_names[] from linux-user as it is unused Leon Alrae
2014-12-17 17:31 ` [Qemu-devel] [PULL 00/30] target-mips queue Peter Maydell
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1418759356-14242-22-git-send-email-leon.alrae@imgtec.com \
--to=leon.alrae@imgtec.com \
--cc=macro@codesourcery.com \
--cc=qemu-devel@nongnu.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).