[Qemu-devel] [PULL 06/17] qcow2: Respect new_block in alloc_refcount_block()

[Kevin Wolf <kwolf@redhat.com>]

From: Max Reitz <mreitz@redhat.com>

When choosing a new place for the refcount table, alloc_refcount_block()
tries to infer the number of clusters used so far from its argument
cluster_index (which comes from the idea that if any cluster with an
index greater than cluster_index was in use, the refcount table would
have to be big enough already to describe cluster_index).

However, there is a cluster that may be at or after cluster_index, and
which is not covered by the refcount structures, and that is the new
refcount block new_block. Therefore, it should be taken into account for
the blocks_used calculation.

Also, because new_block already describes (or is intended to describe)
cluster_index, we may not put the new refcount structures there.

Signed-off-by: Max Reitz <mreitz@redhat.com>
Message-id: 1423598552-24301-2-git-send-email-mreitz@redhat.com
Reviewed-by: Eric Blake <eblake@redhat.com>
Reviewed-by: Kevin Wolf <kwolf@redhat.com>
Signed-off-by: Max Reitz <mreitz@redhat.com>
---
 block/qcow2-refcount.c | 16 ++++++++++++++--
 1 file changed, 14 insertions(+), 2 deletions(-)

diff --git a/block/qcow2-refcount.c b/block/qcow2-refcount.c
index dc8d186..6cbae1d 100644
--- a/block/qcow2-refcount.c
+++ b/block/qcow2-refcount.c
@@ -466,8 +466,20 @@ static int alloc_refcount_block(BlockDriverState *bs,
      */
     BLKDBG_EVENT(bs->file, BLKDBG_REFTABLE_GROW);
 
-    /* Calculate the number of refcount blocks needed so far */
-    uint64_t blocks_used = DIV_ROUND_UP(cluster_index, s->refcount_block_size);
+    /* Calculate the number of refcount blocks needed so far; this will be the
+     * basis for calculating the index of the first cluster used for the
+     * self-describing refcount structures which we are about to create.
+     *
+     * Because we reached this point, there cannot be any refcount entries for
+     * cluster_index or higher indices yet. However, because new_block has been
+     * allocated to describe that cluster (and it will assume this role later
+     * on), we cannot use that index; also, new_block may actually have a higher
+     * cluster index than cluster_index, so it needs to be taken into account
+     * here (and 1 needs to be added to its value because that cluster is used).
+     */
+    uint64_t blocks_used = DIV_ROUND_UP(MAX(cluster_index + 1,
+                                            (new_block >> s->cluster_bits) + 1),
+                                        s->refcount_block_size);
 
     if (blocks_used > QCOW_MAX_REFTABLE_SIZE / sizeof(uint64_t)) {
         return -EFBIG;
-- 
1.8.3.1