[Qemu-devel] [PULL 08/17] block: m25p80: Add configuration registers

[Peter Maydell <peter.maydell@linaro.org>]

From: Marcin Krzeminski <marcin.krzeminski@nokia.com>

This patch adds both volatile and non volatile configuration registers
and commands to allow modify them. It is needed for proper handling
dummy cycles. Initialization of those registers and flash state
has been included as well.
Some of this registers are used by kernel.

Signed-off-by: Marcin Krzeminski <marcin.krzeminski@nokia.com>
Acked-by: Peter Crosthwaite <crosthwaite.peter@gmail.com>
Message-id: 1458719789-29868-7-git-send-email-marcin.krzeminski@nokia.com
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
---
 hw/block/m25p80.c | 128 ++++++++++++++++++++++++++++++++++++++++++++++++++++++
 1 file changed, 128 insertions(+)

diff --git a/hw/block/m25p80.c b/hw/block/m25p80.c
index 14dcaea..3394f22 100644
--- a/hw/block/m25p80.c
+++ b/hw/block/m25p80.c
@@ -26,6 +26,7 @@
 #include "sysemu/block-backend.h"
 #include "sysemu/blockdev.h"
 #include "hw/ssi/ssi.h"
+#include "qemu/bitops.h"
 
 #ifndef M25P80_ERR_DEBUG
 #define M25P80_ERR_DEBUG 0
@@ -82,6 +83,26 @@ typedef struct FlashPartInfo {
 #define JEDEC_WINBOND 0xEF
 #define JEDEC_SPANSION 0x01
 
+/* Numonyx (Micron) Configuration register macros */
+#define VCFG_DUMMY 0x1
+#define VCFG_WRAP_SEQUENTIAL 0x2
+#define NVCFG_XIP_MODE_DISABLED (7 << 9)
+#define NVCFG_XIP_MODE_MASK (7 << 9)
+#define VCFG_XIP_MODE_ENABLED (1 << 3)
+#define CFG_DUMMY_CLK_LEN 4
+#define NVCFG_DUMMY_CLK_POS 12
+#define VCFG_DUMMY_CLK_POS 4
+#define EVCFG_OUT_DRIVER_STRENGHT_DEF 7
+#define EVCFG_VPP_ACCELERATOR (1 << 3)
+#define EVCFG_RESET_HOLD_ENABLED (1 << 4)
+#define NVCFG_DUAL_IO_MASK (1 << 2)
+#define EVCFG_DUAL_IO_ENABLED (1 << 6)
+#define NVCFG_QUAD_IO_MASK (1 << 3)
+#define EVCFG_QUAD_IO_ENABLED (1 << 7)
+#define NVCFG_4BYTE_ADDR_MASK (1 << 0)
+#define NVCFG_LOWER_SEGMENT_MASK (1 << 1)
+#define CFG_UPPER_128MB_SEG_ENABLED 0x3
+
 static const FlashPartInfo known_devices[] = {
     /* Atmel -- some are (confusingly) marketed as "DataFlash" */
     { INFO("at25fs010",   0x1f6601,      0,  32 << 10,   4, ER_4K) },
@@ -245,6 +266,15 @@ typedef enum {
 
     RESET_ENABLE = 0x66,
     RESET_MEMORY = 0x99,
+
+    RNVCR = 0xB5,
+    WNVCR = 0xB1,
+
+    RVCR = 0x85,
+    WVCR = 0x81,
+
+    REVCR = 0x65,
+    WEVCR = 0x61,
 } FlashCMD;
 
 typedef enum {
@@ -271,6 +301,9 @@ typedef struct Flash {
     uint8_t needed_bytes;
     uint8_t cmd_in_progress;
     uint64_t cur_addr;
+    uint32_t nonvolatile_cfg;
+    uint32_t volatile_cfg;
+    uint32_t enh_volatile_cfg;
     bool write_enable;
     bool four_bytes_address_mode;
     bool reset_enable;
@@ -459,6 +492,15 @@ static void complete_collecting_data(Flash *s)
     case EXTEND_ADDR_WRITE:
         s->ear = s->data[0];
         break;
+    case WNVCR:
+        s->nonvolatile_cfg = s->data[0] | (s->data[1] << 8);
+        break;
+    case WVCR:
+        s->volatile_cfg = s->data[0];
+        break;
+    case WEVCR:
+        s->enh_volatile_cfg = s->data[0];
+        break;
     default:
         break;
     }
@@ -477,6 +519,40 @@ static void reset_memory(Flash *s)
     s->write_enable = false;
     s->reset_enable = false;
 
+    if (((s->pi->jedec >> 16) & 0xFF) == JEDEC_NUMONYX) {
+        s->volatile_cfg = 0;
+        s->volatile_cfg |= VCFG_DUMMY;
+        s->volatile_cfg |= VCFG_WRAP_SEQUENTIAL;
+        if ((s->nonvolatile_cfg & NVCFG_XIP_MODE_MASK)
+                                != NVCFG_XIP_MODE_DISABLED) {
+            s->volatile_cfg |= VCFG_XIP_MODE_ENABLED;
+        }
+        s->volatile_cfg |= deposit32(s->volatile_cfg,
+                            VCFG_DUMMY_CLK_POS,
+                            CFG_DUMMY_CLK_LEN,
+                            extract32(s->nonvolatile_cfg,
+                                        NVCFG_DUMMY_CLK_POS,
+                                        CFG_DUMMY_CLK_LEN)
+                            );
+
+        s->enh_volatile_cfg = 0;
+        s->enh_volatile_cfg |= EVCFG_OUT_DRIVER_STRENGHT_DEF;
+        s->enh_volatile_cfg |= EVCFG_VPP_ACCELERATOR;
+        s->enh_volatile_cfg |= EVCFG_RESET_HOLD_ENABLED;
+        if (s->nonvolatile_cfg & NVCFG_DUAL_IO_MASK) {
+            s->enh_volatile_cfg |= EVCFG_DUAL_IO_ENABLED;
+        }
+        if (s->nonvolatile_cfg & NVCFG_QUAD_IO_MASK) {
+            s->enh_volatile_cfg |= EVCFG_QUAD_IO_ENABLED;
+        }
+        if (!(s->nonvolatile_cfg & NVCFG_4BYTE_ADDR_MASK)) {
+            s->four_bytes_address_mode = true;
+        }
+        if (!(s->nonvolatile_cfg & NVCFG_LOWER_SEGMENT_MASK)) {
+            s->ear = CFG_UPPER_128MB_SEG_ENABLED;
+        }
+    }
+
     DB_PRINT_L(0, "Reset done.\n");
 }
 
@@ -611,6 +687,49 @@ static void decode_new_cmd(Flash *s, uint32_t value)
             s->state = STATE_COLLECTING_DATA;
         }
         break;
+    case RNVCR:
+        s->data[0] = s->nonvolatile_cfg & 0xFF;
+        s->data[1] = (s->nonvolatile_cfg >> 8) & 0xFF;
+        s->pos = 0;
+        s->len = 2;
+        s->state = STATE_READING_DATA;
+        break;
+    case WNVCR:
+        if (s->write_enable) {
+            s->needed_bytes = 2;
+            s->pos = 0;
+            s->len = 0;
+            s->state = STATE_COLLECTING_DATA;
+        }
+        break;
+    case RVCR:
+        s->data[0] = s->volatile_cfg & 0xFF;
+        s->pos = 0;
+        s->len = 1;
+        s->state = STATE_READING_DATA;
+        break;
+    case WVCR:
+        if (s->write_enable) {
+            s->needed_bytes = 1;
+            s->pos = 0;
+            s->len = 0;
+            s->state = STATE_COLLECTING_DATA;
+        }
+        break;
+    case REVCR:
+        s->data[0] = s->enh_volatile_cfg & 0xFF;
+        s->pos = 0;
+        s->len = 1;
+        s->state = STATE_READING_DATA;
+        break;
+    case WEVCR:
+        if (s->write_enable) {
+            s->needed_bytes = 1;
+            s->pos = 0;
+            s->len = 0;
+            s->state = STATE_COLLECTING_DATA;
+        }
+        break;
     case RESET_ENABLE:
         s->reset_enable = true;
         break;
@@ -737,6 +856,11 @@ static void m25p80_pre_save(void *opaque)
     flash_sync_dirty((Flash *)opaque, -1);
 }
 
+static Property m25p80_properties[] = {
+    DEFINE_PROP_UINT32("nonvolatile-cfg", Flash, nonvolatile_cfg, 0x8FFF),
+    DEFINE_PROP_END_OF_LIST(),
+};
+
 static const VMStateDescription vmstate_m25p80 = {
     .name = "xilinx_spi",
     .version_id = 2,
@@ -754,6 +878,9 @@ static const VMStateDescription vmstate_m25p80 = {
         VMSTATE_BOOL_V(reset_enable, Flash, 2),
         VMSTATE_UINT8_V(ear, Flash, 2),
         VMSTATE_BOOL_V(four_bytes_address_mode, Flash, 2),
+        VMSTATE_UINT32_V(nonvolatile_cfg, Flash, 2),
+        VMSTATE_UINT32_V(volatile_cfg, Flash, 2),
+        VMSTATE_UINT32_V(enh_volatile_cfg, Flash, 2),
         VMSTATE_END_OF_LIST()
     }
 };
@@ -769,6 +896,7 @@ static void m25p80_class_init(ObjectClass *klass, void *data)
     k->set_cs = m25p80_cs;
     k->cs_polarity = SSI_CS_LOW;
     dc->vmsd = &vmstate_m25p80;
+    dc->props = m25p80_properties;
     dc->reset = m25p80_reset;
     mc->pi = data;
 }
-- 
1.9.1