[Qemu-devel] [PULL 25/25] smbus: do not immediately complete commands

["Michael S. Tsirkin" <mst@redhat.com>]

From: Hervé Poussineau <hpoussin@reactos.org>

PIIX4 errata says that "immediate polling of the Host Status Register BUSY
bit may indicate that the SMBus is NOT busy."
Due to this, some code does the following steps:
(a) set parameters
(b) start command
(c) check for smbus busy bit set (to know that command started)
(d) check for smbus busy bit not set (to know that command finished)

Let (c) happen, by immediately setting the busy bit, and really executing
the command when status register has been read once.

This fixes a problem with AMIBIOS, which can now properly initialize the PIIX4.

Signed-off-by: Hervé Poussineau <hpoussin@reactos.org>
Signed-off-by: Philippe Mathieu-Daudé <f4bug@amsat.org>
---
 hw/i2c/pm_smbus.c | 16 +++++++++++++++-
 1 file changed, 15 insertions(+), 1 deletion(-)

diff --git a/hw/i2c/pm_smbus.c b/hw/i2c/pm_smbus.c
index 6fc3923..ec060d5 100644
--- a/hw/i2c/pm_smbus.c
+++ b/hw/i2c/pm_smbus.c
@@ -63,6 +63,9 @@ static void smb_transaction(PMSMBus *s)
     I2CBus *bus = s->smbus;
     int ret;
 
+    assert(s->smb_stat & STS_HOST_BUSY);
+    s->smb_stat &= ~STS_HOST_BUSY;
+
     SMBUS_DPRINTF("SMBus trans addr=0x%02x prot=0x%02x\n", addr, prot);
     /* Transaction isn't exec if STS_DEV_ERR bit set */
     if ((s->smb_stat & STS_DEV_ERR) != 0)  {
@@ -135,6 +138,13 @@ error:
 
 }
 
+static void smb_transaction_start(PMSMBus *s)
+{
+    /* Do not execute immediately the command ; it will be
+     * executed when guest will read SMB_STAT register */
+    s->smb_stat |= STS_HOST_BUSY;
+}
+
 static void smb_ioport_writeb(void *opaque, hwaddr addr, uint64_t val,
                               unsigned width)
 {
@@ -150,7 +160,7 @@ static void smb_ioport_writeb(void *opaque, hwaddr addr, uint64_t val,
     case SMBHSTCNT:
         s->smb_ctl = val;
         if (val & 0x40)
-            smb_transaction(s);
+            smb_transaction_start(s);
         break;
     case SMBHSTCMD:
         s->smb_cmd = val;
@@ -182,6 +192,10 @@ static uint64_t smb_ioport_readb(void *opaque, hwaddr addr, unsigned width)
     switch(addr) {
     case SMBHSTSTS:
         val = s->smb_stat;
+        if (s->smb_stat & STS_HOST_BUSY) {
+            /* execute command now */
+            smb_transaction(s);
+        }
         break;
     case SMBHSTCNT:
         s->smb_index = 0;
-- 
MST