[Qemu-devel] [PATCH 05/29] vmsvga: Show registers and commands on debug output as decimals

[Liran Alon <liran.alon@oracle.com>]

From: Leonid Shatz <leonid.shatz@oracle.com>

For better readability of debug output, show these values in decimal notation,
as they are defined in source by decimal integers.

Signed-off-by: Leonid Shatz <leonid.shatz@oracle.com>
Reviewed-by: Darren Kenny <darren.kenny@oracle.com>
Signed-off-by: Liran Alon <liran.alon@oracle.com>
---
 hw/display/vmware_vga.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/hw/display/vmware_vga.c b/hw/display/vmware_vga.c
index 2e6ac5dfad8a..2fbb9e7f6c9f 100644
--- a/hw/display/vmware_vga.c
+++ b/hw/display/vmware_vga.c
@@ -773,7 +773,7 @@ static void vmsvga_fifo_run(struct vmsvga_state_s *s)
                 vmsvga_fifo_read(s);
             }
             if (!cmd_ignored) {
-                printf("%s: Unknown command 0x%02x in SVGA command FIFO\n",
+                printf("%s: Unknown command %d in SVGA command FIFO\n",
                        __func__, cmd);
             }
             break;
@@ -964,7 +964,7 @@ static uint32_t vmsvga_value_read(void *opaque, uint32_t address)
             ret = s->scratch[s->index - SVGA_SCRATCH_BASE];
             break;
         }
-        printf("%s: Bad register %02x\n", __func__, s->index);
+        printf("%s: Bad register %d\n", __func__, s->index);
         ret = 0;
         break;
     }
@@ -1092,7 +1092,7 @@ static void vmsvga_value_write(void *opaque, uint32_t address, uint32_t value)
             s->scratch[s->index - SVGA_SCRATCH_BASE] = value;
             break;
         }
-        printf("%s: Bad register %02x\n", __func__, s->index);
+        printf("%s: Bad register %d\n", __func__, s->index);
     }
 }
 
-- 
1.9.1