Re: [Qemu-devel] [PATCH 2/2] device_isolation: Support isolation on POWER p7ioc (IODA) bridges

[David Gibson <david@gibson.dropbear.id.au>]

[-- Attachment #1: Type: text/plain, Size: 1443 bytes --]

On Thu, Dec 15, 2011 at 05:48:38PM +1100, Michael Ellerman wrote:
> On Thu, 2011-12-15 at 17:08 +1100, David Gibson wrote:
> > This patch adds code to the code for the powernv platform to create
> > and populate isolation groups on hardware using the p7ioc (aka IODA) PCI host
> > bridge used on some IBM POWER systems.
> 
> > diff --git a/arch/powerpc/platforms/powernv/pci-ioda.c b/arch/powerpc/platforms/powernv/pci-ioda.c
> > index 0cdc8302..6df632e 100644
> > --- a/arch/powerpc/platforms/powernv/pci-ioda.c
> > +++ b/arch/powerpc/platforms/powernv/pci-ioda.c
> > @@ -861,6 +862,9 @@ static void __devinit pnv_ioda_setup_bus_dma(struct pnv_ioda_pe *pe,
> >  		set_iommu_table_base(&dev->dev, &pe->tce32_table);
> >  		if (dev->subordinate)
> >  			pnv_ioda_setup_bus_dma(pe, dev->subordinate);
> > +#ifdef CONFIG_DEVICE_ISOLATION
> > +		device_isolation_dev_add(&pe->di_group, &dev->dev);
> > +#endif
> 
> You already have a nop version of that in device_isolation.h, so the
> ifdef is not required AFAICS.

Alas, this is not true, since the pe->di_group member will not exist
if !CONFIG_DEVICE_ISOLATION.  And the stub is an inline, not a macro.

The stubs probably can be fine tuned to avoid ifdefs in more places.

-- 
David Gibson			| I'll have my music baroque, and my code
david AT gibson.dropbear.id.au	| minimalist, thank you.  NOT _the_ _other_
				| _way_ _around_!
http://www.ozlabs.org/~dgibson

[-- Attachment #2: Digital signature --]
[-- Type: application/pgp-signature, Size: 198 bytes --]