Re: [Qemu-devel] [RFC] vhost: Can we change synchronize_rcu to call_rcu in vhost_set_memory() in vhost kernel module?

["Michael S. Tsirkin" <mst@redhat.com>]

On Mon, May 12, 2014 at 11:57:32AM +0200, Paolo Bonzini wrote:
> Il 12/05/2014 11:28, Gonglei (Arei) ha scritto:
> >From previous discussion:
> >https://lists.gnu.org/archive/html/qemu-devel/2014-03/msg04925.html
> >we know that you are going to replace RCU in KVM_SET_GSI_ROUTING with SRCU. Though
> >SRCU is quite better than originally RCU, in our test case this cannot satisfy our needs. Our VMs
> >work in telecom scenario, VMs report CPU and memory usage to balance node each second, and
> >balance node dispatch works to different VMs according to VM load. Since this balance needs
> >high accuracy, IRQ affinity settings in VM also need high accuracy, so we balance IRQ affinity in
> >every 0.5s. So for telecom scenario, KVM_SET_GSI_ROUTING IOCTL needs much optimization.
> >And in live migration case, VHOST_SET_MEM_TABLE needs attention.
> >
> >We tried to change synchronize_rcu() to call_rcu() with rate limit, but rate limit is not easy to
> >configure. Do you have better ideas to achieve this? Thanks.
> 
> Perhaps we can check for cases where only the address is changing,
> and poke at an existing struct kvm_kernel_irq_routing_entry without
> doing any RCU synchronization?

I suspect interrupts can get lost then: e.g. if address didn't match any
cpus, not it matches some. No?

> As long as kvm_set_msi_irq only reads address_lo once, it should work.
> 
> VHOST_SET_MEM_TABLE is a different problem.  What happens in
> userspace that leads to calling that ioctl?  Can we remove it
> altogether, or delay it to after the destination has started
> running?
> 
> Paolo