From: "Dr. David Alan Gilbert" <dgilbert@redhat.com>
To: Dmitry Fleytman <dmitry@daynix.com>
Cc: qemu-devel@nongnu.org
Subject: Re: [Qemu-devel] e1000e migration
Date: Mon, 15 May 2017 10:22:52 +0100 [thread overview]
Message-ID: <20170515092251.GB2089@work-vm> (raw)
In-Reply-To: <225AC0F4-5672-456F-9032-F2C1C86342E5@daynix.com>
* Dmitry Fleytman (dmitry@daynix.com) wrote:
> Hello Dave,
Hi Dmitry,
Thanks for the reply.
> We are trying to reproduce this issue on our systems but with no luck so far…
Note our QE hit this with both a Win8.1 and a win2012r2 guest - although
the 2012r2 is reported to have recoverd after a few minutes.
2016 apparently works OK.
> From what you describe it looks like some bit in ICR is not being cleared by the driver.
> This usually means that this bit should never be set in that specific interrupt mode.
>
> Could you please check which bit is not cleared and who sets it?
The full set of e1000e_irq_pending_interrupts after migration is:
23004@1494519346.673905:e1000e_irq_pending_interrupts ICR PENDING: 0x100000 (ICR: 0x80100082, IMS: 0x1f00004)
23004@1494519346.674787:e1000e_irq_pending_interrupts ICR PENDING: 0x0 (ICR: 0x80100082, IMS: 0x1e00004)
23004@1494519346.674946:e1000e_irq_pending_interrupts ICR PENDING: 0x0 (ICR: 0x80100082, IMS: 0x1e00004)
23004@1494519346.675119:e1000e_irq_pending_interrupts ICR PENDING: 0x200000 (ICR: 0x80300082, IMS: 0x1e00004)
23004@1494519346.675302:e1000e_irq_pending_interrupts ICR PENDING: 0x0 (ICR: 0x80100082, IMS: 0x1c00004)
<repeated lots>
23004@1494519346.716279:e1000e_irq_pending_interrupts ICR PENDING: 0x0 (ICR: 0x80300082, IMS: 0x1c00004)
23004@1494519346.716380:e1000e_irq_pending_interrupts ICR PENDING: 0x1000000 (ICR: 0x813000c2, IMS: 0x1c00004)
23004@1494519346.717040:e1000e_irq_pending_interrupts ICR PENDING: 0x1000000 (ICR: 0x813000c2, IMS: 0x1400004)
23004@1494519346.717276:e1000e_irq_pending_interrupts ICR PENDING: 0x1000000 (ICR: 0x813000c2, IMS: 0x1000004)
23004@1494519346.717443:e1000e_irq_pending_interrupts ICR PENDING: 0x0 (ICR: 0x813000c2, IMS: 0x4)
23004@1494519346.717567:e1000e_irq_pending_interrupts ICR PENDING: 0x0 (ICR: 0x813000c2, IMS: 0x4)
23004@1494519346.717782:e1000e_irq_pending_interrupts ICR PENDING: 0x0 (ICR: 0x813000c2, IMS: 0x4)
23004@1494519346.717918:e1000e_irq_pending_interrupts ICR PENDING: 0x0 (ICR: 0x813000c2, IMS: 0x4)
23004@1494519346.718319:e1000e_irq_pending_interrupts ICR PENDING: 0x0 (ICR: 0x813000c2, IMS: 0x4)
23004@1494519346.718523:e1000e_irq_pending_interrupts ICR PENDING: 0x200000 (ICR: 0x813000c2, IMS: 0xa00004)
23004@1494519346.718684:e1000e_irq_pending_interrupts ICR PENDING: 0x0 (ICR: 0x811000c2, IMS: 0x4)
23004@1494519346.718890:e1000e_irq_pending_interrupts ICR PENDING: 0x0 (ICR: 0x811000c2, IMS: 0x4)
23004@1494519346.719034:e1000e_irq_pending_interrupts ICR PENDING: 0x0 (ICR: 0x811000c2, IMS: 0xa00004)
23004@1494519346.719130:e1000e_irq_pending_interrupts ICR PENDING: 0x0 (ICR: 0x811000c2, IMS: 0xa00004)
<repeats>
23004@1494519346.722699:e1000e_irq_pending_interrupts ICR PENDING: 0x0 (ICR: 0x811000c2, IMS: 0xa00004)
23004@1494519346.722868:e1000e_irq_pending_interrupts ICR PENDING: 0x200000 (ICR: 0x813000c2, IMS: 0xa00004)
23004@1494519346.723068:e1000e_irq_pending_interrupts ICR PENDING: 0x0 (ICR: 0x811000c2, IMS: 0x800004)
<repeats>
23004@1494519346.731198:e1000e_irq_pending_interrupts ICR PENDING: 0x0 (ICR: 0x813000c2, IMS: 0x800004)
23004@1494519346.731422:e1000e_irq_pending_interrupts ICR PENDING: 0x0 (ICR: 0x813000c2, IMS: 0x4)
23004@1494519346.731930:e1000e_irq_pending_interrupts ICR PENDING: 0x200000 (ICR: 0x813000c2, IMS: 0xa00004)
23004@1494519346.732082:e1000e_irq_pending_interrupts ICR PENDING: 0x0 (ICR: 0x811000c2, IMS: 0x4)
23004@1494519346.732274:e1000e_irq_pending_interrupts ICR PENDING: 0x0 (ICR: 0x811000c2, IMS: 0x4)
23004@1494519346.732404:e1000e_irq_pending_interrupts ICR PENDING: 0x0 (ICR: 0x811000c2, IMS: 0xa00004)
23004@1494519346.732504:e1000e_irq_pending_interrupts ICR PENDING: 0x0 (ICR: 0x811000c2, IMS: 0xa00004)
23004@1494519346.784150:e1000e_irq_pending_interrupts ICR PENDING: 0x0 (ICR: 0x815000c2, IMS: 0xa00004)
23004@1494519346.786506:e1000e_irq_pending_interrupts ICR PENDING: 0x0 (ICR: 0x815000c2, IMS: 0xa00004)
23004@1494519346.786534:e1000e_irq_pending_interrupts ICR PENDING: 0x0 (ICR: 0x815000c2, IMS: 0xa00004)
23004@1494519346.789644:e1000e_irq_pending_interrupts ICR PENDING: 0x1000000 (ICR: 0x815000c2, IMS: 0x1a00004)
23004@1494519346.789864:e1000e_irq_pending_interrupts ICR PENDING: 0x0 (ICR: 0x815000c2, IMS: 0xa00004)
23004@1494519346.789992:e1000e_irq_pending_interrupts ICR PENDING: 0x0 (ICR: 0x815000c2, IMS: 0xa00004)
23004@1494519346.790413:e1000e_irq_pending_interrupts ICR PENDING: 0x0 (ICR: 0x815000c2, IMS: 0xa00004)
23004@1494519346.790539:e1000e_irq_pending_interrupts ICR PENDING: 0x0 (ICR: 0x815000c2, IMS: 0xa00004)
23004@1494519346.792593:e1000e_irq_pending_interrupts ICR PENDING: 0x0 (ICR: 0x815000c2, IMS: 0xa00004)
23004@1494519346.792620:e1000e_irq_pending_interrupts ICR PENDING: 0x0 (ICR: 0x815000c2, IMS: 0xa00004)
23004@1494519346.795943:e1000e_irq_pending_interrupts ICR PENDING: 0x1000000 (ICR: 0x815000c2, IMS: 0x1a00004)
and then I think we get stuck in this cycle of this one always being the
one that fires repeatedly. I think that's the 'other' firing, I think
because of the receive-overrun. One thing I've not
figured out is why the receive overrun happens - is that because we
really have a very heavy packet rate or is it because something has
stopped receiving them.
The network I'm testing on does have a fair amount of broadcast traffic
on.
Dave
> Regards,
> Dmitry
>
> > On 11 May 2017, at 15:36 PM, Dr. David Alan Gilbert <dgilbert@redhat.com> wrote:
> >
> > Hi Dmitry,
> > Have you seen any problems with e1000e migration under windows?
> > I've got a repeatable case where after migration with e1000e windows
> > hangs/almost hangs.
> > I'm seeing the e1000e generate interrupts at a very very high
> > rate (maybe ~1000 second ish?) after migration.
> >
> > Some versions of qemu do it and some dont, but my attempts
> > at bisection lead me to code that should be irrelevant.
> >
> > Prior to migration I see:
> >
> > 36461@1494504466.711929:e1000e_irq_pending_interrupts ICR PENDING: 0x100000 (ICR: 0x80100082, IMS: 0x1f00004)
> > 36461@1494504466.711992:e1000e_irq_pending_interrupts ICR PENDING: 0x0 (ICR: 0x80000082, IMS: 0x1a00004)
> > 36461@1494504466.712076:e1000e_irq_pending_interrupts ICR PENDING: 0x0 (ICR: 0x80000082, IMS: 0x1f00004)
> > 36461@1494504466.712245:e1000e_irq_pending_interrupts ICR PENDING: 0x0 (ICR: 0x80000082, IMS: 0x1a00004)
> > 36461@1494504466.712332:e1000e_irq_pending_interrupts ICR PENDING: 0x0 (ICR: 0x80000082, IMS: 0x1f00004)
> >
> > which I think the ICR means:
> > 31 - int asserted
> > 20 - RxQ0 - receive queue 0 interrupt
> > 7 - RXT0 - receiver timer interrupt
> > 1 - TXQE - Transmit Queue empty
> >
> > after migration it varies more, I'm seeing mostly:
> > 21977@1494504516.320707:e1000e_irq_pending_interrupts ICR PENDING: 0x1000000 (ICR: 0x815000c2, IMS: 0x1a00004)
> > 31 - int asserted
> > 24 - 'Other'
> > 22 - TxQ0 interrupt
> > 20 - RxQ0 interrupt
> > 07 - RXT0 Receiver timer interrupt
> > 06 - RX0 - Receiver overrun
> > 01 - TXQE - Transmit queue empty
> >
> > For reference this is https://bugzilla.redhat.com/show_bug.cgi?id=1447935
> >
> > Dave
> > --
> > Dr. David Alan Gilbert / dgilbert@redhat.com / Manchester, UK
>
--
Dr. David Alan Gilbert / dgilbert@redhat.com / Manchester, UK
next prev parent reply other threads:[~2017-05-15 9:23 UTC|newest]
Thread overview: 5+ messages / expand[flat|nested] mbox.gz Atom feed top
2017-05-11 12:36 [Qemu-devel] e1000e migration Dr. David Alan Gilbert
2017-05-14 13:14 ` Dmitry Fleytman
2017-05-15 9:22 ` Dr. David Alan Gilbert [this message]
2017-05-15 16:13 ` Dmitry Fleytman
2017-05-15 16:14 ` Dr. David Alan Gilbert
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20170515092251.GB2089@work-vm \
--to=dgilbert@redhat.com \
--cc=dmitry@daynix.com \
--cc=qemu-devel@nongnu.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).