[Qemu-devel] [PULL 02/18] quorum: Set sectors-count to 0 when reporting a flush error

[Kevin Wolf <kwolf@redhat.com>]

From: Alberto Garcia <berto@igalia.com>

The QUORUM_REPORT_BAD event has fields to report the sector in which
the error was detected and the number of affected sectors starting
from that one. This is important for read and write errors, but not
for flush errors.

For flush errors the current code reports the total size of the disk
image. That is however not useful information in this case. Moreover,
the bdrv_getlength() call can fail, and there's no good way of
handling that failure.

Since we're reporting useless information and we cannot even guarantee
to do it in a consistent way, this patch changes the code to report 0
instead in all cases.

Reported-by: Markus Armbruster <armbru@redhat.com>
Signed-off-by: Alberto Garcia <berto@igalia.com>
Reviewed-by: Eric Blake <eblake@redhat.com>
Signed-off-by: Kevin Wolf <kwolf@redhat.com>
---
 block/quorum.c | 3 +--
 1 file changed, 1 insertion(+), 2 deletions(-)

diff --git a/block/quorum.c b/block/quorum.c
index 55ba916655..d04da4f430 100644
--- a/block/quorum.c
+++ b/block/quorum.c
@@ -785,8 +785,7 @@ static coroutine_fn int quorum_co_flush(BlockDriverState *bs)
     for (i = 0; i < s->num_children; i++) {
         result = bdrv_co_flush(s->children[i]->bs);
         if (result) {
-            quorum_report_bad(QUORUM_OP_TYPE_FLUSH, 0,
-                              bdrv_getlength(s->children[i]->bs),
+            quorum_report_bad(QUORUM_OP_TYPE_FLUSH, 0, 0,
                               s->children[i]->bs->node_name, result);
             result_value.l = result;
             quorum_count_vote(&error_votes, &result_value, i);
-- 
2.13.4