From: Alexey Kardashevskiy <aik@ozlabs.ru>
To: qemu-devel@nongnu.org
Cc: Alexey Kardashevskiy <aik@ozlabs.ru>,
qemu-ppc@nongnu.org, David Gibson <david@gibson.dropbear.id.au>,
Alex Williamson <alex.williamson@redhat.com>
Subject: [Qemu-devel] [PATCH qemu v2] vfio/spapr: Allow backing bigger guest IOMMU pages with smaller physical pages
Date: Wed, 20 Jun 2018 19:10:12 +1000 [thread overview]
Message-ID: <20180620091013.2224-1-aik@ozlabs.ru> (raw)
At the moment the PPC64/pseries guest only supports 4K/64K/16M IOMMU
pages and POWER8 CPU supports the exact same set of page size so
so far things worked fine.
However POWER9 supports different set of sizes - 4K/64K/2M/1G and
the last two - 2M and 1G - are not even allowed in the paravirt interface
(RTAS DDW) so we always end up using 64K IOMMU pages, although we could
back guest's 16MB IOMMU pages with 2MB pages on the host.
This stores the supported host IOMMU page sizes in VFIOContainer and uses
this later when creating a new DMA window. This uses the system page size
(64k normally, 2M/16M/1G if hugepages used) as the upper limit of
the IOMMU pagesize.
This changes the type of @pagesize to uint64_t as this is what
memory_region_iommu_get_min_page_size() returns and clz64() takes.
There should be no behavioral changes on platforms other than pseries.
The guest will keep using the IOMMU page size selected by the PHB pagesize
property as this only changes the underlying hardware TCE table
granularity.
Signed-off-by: Alexey Kardashevskiy <aik@ozlabs.ru>
---
Changes:
v2:
* fixed biggest but smaller page size calculation
* limit IOMMU pagesize to the system pagesize
---
include/hw/vfio/vfio-common.h | 1 +
hw/vfio/common.c | 3 +++
hw/vfio/spapr.c | 21 ++++++++++++++++++++-
3 files changed, 24 insertions(+), 1 deletion(-)
diff --git a/include/hw/vfio/vfio-common.h b/include/hw/vfio/vfio-common.h
index a903692..c20524d 100644
--- a/include/hw/vfio/vfio-common.h
+++ b/include/hw/vfio/vfio-common.h
@@ -73,6 +73,7 @@ typedef struct VFIOContainer {
unsigned iommu_type;
int error;
bool initialized;
+ unsigned long pgsizes;
/*
* This assumes the host IOMMU can support only a single
* contiguous IOVA window. We may need to generalize that in
diff --git a/hw/vfio/common.c b/hw/vfio/common.c
index fb396cf..40f0356 100644
--- a/hw/vfio/common.c
+++ b/hw/vfio/common.c
@@ -1108,6 +1108,7 @@ static int vfio_connect_container(VFIOGroup *group, AddressSpace *as,
info.iova_pgsizes = 4096;
}
vfio_host_win_add(container, 0, (hwaddr)-1, info.iova_pgsizes);
+ container->pgsizes = info.iova_pgsizes;
} else if (ioctl(fd, VFIO_CHECK_EXTENSION, VFIO_SPAPR_TCE_IOMMU) ||
ioctl(fd, VFIO_CHECK_EXTENSION, VFIO_SPAPR_TCE_v2_IOMMU)) {
struct vfio_iommu_spapr_tce_info info;
@@ -1172,6 +1173,7 @@ static int vfio_connect_container(VFIOGroup *group, AddressSpace *as,
}
if (v2) {
+ container->pgsizes = info.ddw.pgsizes;
/*
* There is a default window in just created container.
* To make region_add/del simpler, we better remove this
@@ -1186,6 +1188,7 @@ static int vfio_connect_container(VFIOGroup *group, AddressSpace *as,
}
} else {
/* The default table uses 4K pages */
+ container->pgsizes = 0x1000;
vfio_host_win_add(container, info.dma32_window_start,
info.dma32_window_start +
info.dma32_window_size - 1,
diff --git a/hw/vfio/spapr.c b/hw/vfio/spapr.c
index 259397c..becf71a 100644
--- a/hw/vfio/spapr.c
+++ b/hw/vfio/spapr.c
@@ -15,6 +15,7 @@
#include "hw/vfio/vfio-common.h"
#include "hw/hw.h"
+#include "exec/ram_addr.h"
#include "qemu/error-report.h"
#include "trace.h"
@@ -144,9 +145,27 @@ int vfio_spapr_create_window(VFIOContainer *container,
{
int ret;
IOMMUMemoryRegion *iommu_mr = IOMMU_MEMORY_REGION(section->mr);
- unsigned pagesize = memory_region_iommu_get_min_page_size(iommu_mr);
+ uint64_t pagesize = memory_region_iommu_get_min_page_size(iommu_mr);
unsigned entries, pages;
struct vfio_iommu_spapr_tce_create create = { .argsz = sizeof(create) };
+ long systempagesize = qemu_getrampagesize();
+
+ /*
+ * The host might not support the guest supported IOMMU page size,
+ * so we will use smaller physical IOMMU pages to back them.
+ */
+ if (pagesize > systempagesize) {
+ pagesize = systempagesize;
+ }
+ pagesize = 1ULL << (63 - clz64(container->pgsizes &
+ (pagesize | (pagesize - 1))));
+ if (!pagesize) {
+ error_report("Host doesn't support page size 0x%"PRIx64
+ ", the supported mask is 0x%lx",
+ memory_region_iommu_get_min_page_size(iommu_mr),
+ container->pgsizes);
+ return -EINVAL;
+ }
/*
* FIXME: For VFIO iommu types which have KVM acceleration to
--
2.11.0
next reply other threads:[~2018-06-20 9:10 UTC|newest]
Thread overview: 5+ messages / expand[flat|nested] mbox.gz Atom feed top
2018-06-20 9:10 Alexey Kardashevskiy [this message]
2018-07-20 6:09 ` [Qemu-devel] [PATCH qemu v2] vfio/spapr: Allow backing bigger guest IOMMU pages with smaller physical pages Alexey Kardashevskiy
2018-07-23 3:11 ` David Gibson
2018-07-24 3:56 ` Alexey Kardashevskiy
2018-07-26 1:41 ` David Gibson
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20180620091013.2224-1-aik@ozlabs.ru \
--to=aik@ozlabs.ru \
--cc=alex.williamson@redhat.com \
--cc=david@gibson.dropbear.id.au \
--cc=qemu-devel@nongnu.org \
--cc=qemu-ppc@nongnu.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).