Re: [Qemu-devel] [PATCH 2/2] scsi: esp: Improve consistency of RSTAT, RSEQ, and RINTR

[Guenter Roeck <linux@roeck-us.net>]

On Thu, Nov 29, 2018 at 06:34:54PM +0000, Mark Cave-Ayland wrote:
> On 29/11/2018 17:38, Guenter Roeck wrote:
> 
> > Can you try the attached patch ? It is a bit cleaner than the first version,
> > and works for me as well.
> > 
> > Note that this isn't perfect. Specifically, I see differences in handling
> > STAT_TC. The controller specification is a bit ambiguous in that regard,
> > but comparing the qemu code with real controller behavior shows that the
> > real controller does not reset STAT_TC when reading the interrupt status
> > register. That doesn't seem to matter for Linux, but it may influence
> > other guests.
> 
> I've now completed a boot test of all my SPARC32 OpenBIOS CDROM images with this
> patch, and whilst it doesn't solve my NextSTEP issue, I don't see any obvious
> regressions.
> 
> Note that NetBSD SPARC32 tends to spit out the occasional "!TC on data xfer" message
> to the console during periods of disk access, however that is something that has
> always happened and isn't something new introduced by this patch.
> 

That may be because reading the interrupt status resets the TC bit.
As mentioned above, I think it shouldn't do that. Just a wild guess, but
it might be worth a try. Can you remove "s->rregs[ESP_RSTAT] &= ~STAT_TC;"
from the ESP_RINTR case in esp_reg_read() and see what happens ?

[That may expose situations where STAT_TC _should_ be cleared but isn't,
 so we may hit other problems when doing that.]

Thanks,
Guenter